PRODUCT SPECIFICATION 1 X 2 WI-FI MODULE ROKU WM02 Version 1.0 Liteon PN: AAZ200007G This document contains confidential proprietary information and is property of LTC. The contents of this document should not be disclosed to unauthorized persons without the written consent of LTC. Change History: Revision Version 1.
CONTENT PRODUCT FEATURES ....................................................................................................................3 PRODUCT SPECIFICATIONS........................................................................................................3 MAIN CHIPSET ........................................................................................................................................3 FUNCTIONAL SPECIFICATIONS ................................................................
PRODUCT FEATURES • Operate at 2.4GHz band • 150Mbps PHY Rate Support • 1T1R Modes • USB 2.0 support for date rates up to 12Mbps full speed and 480Mbps high speed • IEEE standards support: IEEE 802.11b/g and 802.11n • 802.11i- WEP 64/128, AES, TKIP • Support Wi-Fi Direct • RoHS compliance • Low Halogen compliance Product specifications Main chipset MAC/Baseband/RF: Broadcom BCM43143 Functional Specifications Standard IEEE802.11b; IEEE 802.11g; IEEE802.11n Bus Interface Universal Serial Bus (USB2.
Security 64-bit, 128-bit WEP, TKIP, AES, WPA, WPA2, WPS IEEE 802.11i Operating Voltage 3.3V ±9% I/O supply voltage Power Consumption 299.62mA/381.89mA(Mean/Max) 988.746mW/1260.237mW(3.3V) Antenna Type Antenna 1: On-board metal PIFA-type antenna Antenna 2: Stand-alone metal PIFA with soldered mini-coaxial cable using male U.FL.
Product Picture Top Pin definition Pin Number 1 2 3 4 5 6 Block Diagram Pin Name VCC(3V3) DD+ GND NC RESETn Bottom
EEPROM INFORMATION Vendor ID 0x0A5C Product ID 0xBD1E ENVIRONMENTAL Operating Operating Temperature: 0 to 40C Relative Humidity: 5-90% (non-condensing) Storage Temperature: -40 to 80C Relevant Humidity: 5-80% (non-condensing) PACKING SPEC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digi tal device, pursuant to part 15 of the FCC rules.
2. Only those antennas with same type and lesser gain filed under this FCC ID number c an be used with this device. 3. The regulatory label on the final system must include the statement: “Contains FCC I D: xxxx “. 4. The final system integrator must ensure there is no instruction provided in the user manual or customer documentation indicating how to install or remove the transmitter module except such device has implemented twoways authentication between module and the host system. 5.
IC Statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.