Aroco AC-BLE-T110 iBeacon Quick Start Guide Revision: v1.
Specification AC-BLE-T110: Mechanics Data Size Approx. 60.3 x 43.3 x 21.1 mm Weight Approx. 25 grams (without Battery) Approx. 34 grams (with Battery) Casing PC/ABS Case Electrics Data Bluetooth Chip Nordic nRF52840 Frequency 2.4GHz Memory 256kB Ram, 1MB Flash BLE Version Bluetooth 5 compatible iBeacon compatible BT4.
Instructions for Connect the Beacon 1. Download the Aroco Beacon Configuration Android App (version 1.2) from following QR Code url: Android version: 5.1 or upper 2. Unscrew the screw and open the cover. Fill in battery CR2477 to Turn On the Beacon.
3. Start the App. Allow Device’s Location permission, Enable Bluetooth and Location.
4. Press the Change Mode Button on the Beacon board.
5. Press Connect button on the Mobile App to scan and connect the Beacon. 6. Select the Beacon and Tap to connect. All current parameter will be read.
Beacon Configuration
UUID: 16 Bytes UUID data can be changed. Non-hexadecimal content will be blocked. (Default: aa55bb44cc33dd22ee11+6bytes Beacon MAC address) • If new UUID length not 32, the notice will be shown as below and all parameter cannot be updated. Manufacturing Code: 2 Bytes Code data can be changed. Non-hexadecimal content will be blocked. (Default: 0x004C) • If new Mfg. Code is empty, the notice will be shown as below and all parameter cannot be updated.
TX Power (dBm): Combo Box choice include -20, -16, -12, -8, -4, 0, 2, 3, 4, 5, 6, 7, 8 (Default: 12) 2 x Adv: Tick box for data advertising by Double Advertisement Advertising Interval (ms): Range 50-3600000. (Default: 650) • If new Adv. Interval is empty or less than 50, the notice will be shown as below and all parameter cannot be updated. Advertising Type: Tick Box to choice Normal Type (BT4.2) or/ and Long Range Type (BT5) (Default: Normal (BT4.
PIN: 4 digits PIN (Alphabet or number) for Login when every connection create (Default: 1234) • If new PIN length not 4, the notice will be shown as below and all parameter cannot be updated to Device after press “Send Config” button. * Configuration APP will send all the above parameter to change the Beacon config by press Send Config Button. No any parameter will be updated individually if any input error notice appear.