Quick start Guide

AI-1 Quickstart Guide
1
Connect AI-1 Interface
to computer
Connect microphone or instrument
2
*cable not included
Enable Phantom Power (P48)
This is required for condenser microphones
3
Enable P48
Press left knob to enable,
P48 light illuminates red
A
B
Disable P48 for dynamic
microphones
Press left knob to disable,
P48 light darkens
OFF
Set input level
4
Green is good
A
Turn down when Red
B
Connect headphones, adjust volume
5
*headphones not included
Enable Direct Monitor by pressing right knob
6
ON - Signal goes from
mic direct to headphone
output
A
If desired, connect powered speakers
7
*disconnect headphones to activate speaker output
You’re now
ready to create!
Love your new product?
Share with us #rodeai1
Scan the
QR code
to find
out more
@
rodemic
@
rodemics
rodemic
www.rode.com
OFF - Signal goes from
mic through computer to
headphones
B