Installation Instructions

Table Of Contents
LED Remote Controller
Rm15
Meshlink Wireless
Click to turn ON/OFF lights,
Switch from one effect(
brightness, color, dynamic
mode) to another from the
library
Remote indicator, blinks
when key(s) pressed.
Function
Operation
1. Pair the remote to receiver
The remote controller needs to be paired to receiver for proper working. User need
activate the remote before paring and each remote controller can be paired to any
receiver.
To pair a new remote to the receiver, please operate with following two steps:
1). Press remote and key simultaneously and it will goes into the searching
mode in the coming 30 seconds.
2). Go to the Setup page and select Add new device, then search initial device and
add it to target device group.
Specification
Working voltage
Wireless protocol
Frequency band
Wireless power
Working temperature
Single Color / CCT / RGB
Dimming &
Color control
DC 3V, CR2032 battery
Bluetooth low energy
2.4GHz ISM band
< 7dBm
-20-55 C(-4-131 F)
Battery:
CR2032
Remove
before use
FCC NOTICE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for
help.
To assure continued operation, follow the attached installation
instructions and use only shield cables when connecting to other devices.
Changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC ID: 2AA7SRM15CXZJ

Summary of content (1 pages)