User's Manual

ManualsBrandsRockford ManualsElectronicsOLED remote

FS-60

2-Way OLED Remote

Paging Alarm & Engine Starting System

OPERATION INSTRUCTIONS

INTRODUCTION

CONGRATULATIONS on your choice of the OLED Remote Paging Alarm & Remote Engine

Starting System with 3 D Graphics by Crimestopper Security Products Inc.

CONTACT INFORMATION:

TECHNICAL SUPPORT (800)-998-6880

Monday - Friday 8:00am - 4:30pm Pacific

Website: www.crimestopper.com

E-mail: techsupport07@crimestopper.com

CRIMESTOPPER SECURITY PRODUCTS INC.

1770 S. TAPO STREET

SIMI VALLEY, CA. 93063 REV. A 7.2009

This device complies with FCC Rules part 15. Operation is subject to the

following two conditions: 1) This device may not cause interference, and (2) this

device must accept any interference that may be received, including

interference that may cause undesired operation. The manufacturer is not

responsible for any radio or TV interference caused by unauthorized

modification to this equipment. Such modification could void the user's authority

to operate the equipment.

Summary of content (14 pages)

PAGE 1
FS-60 2-Way OLED Remote Paging Alarm & Engine Starting System OPERATION INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of the OLED Remote Paging Alarm & Remote Engine Starting System with 3 D Graphics by Crimestopper Security Products Inc. This device complies with FCC Rules part 15.
PAGE 2
THE REMOTE CONTROLS 1-WAY - SIDEKICK REMOTE: The 1-Way sidekick remote adds flexibility to your system. You can have the convenience of operating your system without needing to carry the larger pager remote. The Sidekick remote has less range and offers all of the same operation features except for page-back confirmation. The 1-Way Sidekick Remote uses two CR-2025 Lithium 3 Volt Batteries.
PAGE 3
• Scroll Scroll-Wheel “UP” to display the Following screens • Scroll Scroll-Wheel “DOWN” to display the Following screens Power OFF Button: Scroll-Wheel Down This turns the Power Off. The Remote will not receive signals from vehicle until button # 4 is pressed about 4 seconds. The screen will change colors, and then show Start-Up Screen. Arming / Locking: Press the Lock Button on the remote control.
PAGE 4
Disarming / Unlocking: Press the Unlock Button on the remote control. The System will disarm and confirm with two chirps, two light flashes, and the LED will turn off. Power locks will unlock and Interior Dome light will turn on (if installed with these optional features). The 2-Way LCD Pager will confirm with “System Disarmed” while displaying an Unlock symbol.
PAGE 5
Manual Arming Mode: The alarm system can be Manually Armed and Disarmed without the remote control. The door entry will change to a 20 second delay to allow disarm without sounding alarm. This is useful if you don’t have a remote control or go swimming. To Activate Manual Mode: 1. Turn Ignition Key off. 2. Press Valet Override Button 3 times and exit vehicle. 3. The system will arm 10 seconds after closing the door. 4. Disarm by Ignition On and press Valet Override button 4 seconds.
PAGE 6
Prior intrusion Alert: This system will notify you if the alarm was triggered while you were away. Upon disarming, there will be four siren chirps instead of the two normal disarm chirps. Check your vehicle for any signs of a break in or tampering. The Blue Status LED will flash the trigger zone number as follows: 2 LED Flashes = Sensor # 1 3 LED Flashes = Sensor # 2 4 LED Flashes = Trunk 5 LED Flashes = Door Diagnostics will reset when the Ignition is turned on or when the system is re-armed.
PAGE 7
Arming Reminder: (Option # 6-1 = ON, # 6-4 = OFF) If Passive Arming is turned off, there is a reminder to arm the system 15 seconds after closing the last door. The system will chirp 4 times to remind you to arm the alarm. Active Rearm: (Option # 5-4) Active Rearming means that the system will re-arm itself 30 seconds after being disarmed with the transmitter if a door has not yet been opened. This is handy if the vehicle is accidentally disarmed (via the transmitter in your pocket) without you knowing it.
PAGE 8
Button Beeps: Scroll-Wheel Down Press button # 1 for beeps when a key is pressed on remote control. The menu will show ON or OFF. Vibration and Melody: Scroll-Wheel Down Press button # 2 for Vibration ON/OFF. Press button # 2 a second time for Voice Confirmation ON/OFF. The menu will show ON or OFF for each selection. Button Lock: Scroll-Wheel Down To prevent accidental operation of alarm system, the remote control has a button lock function. Pressing any remote button will display the Button Lock Screen.
PAGE 9
Parking Timer: This is a parking meter alarm reminder. Enter the amount of time needed using the Scroll-Wheel. Press button # 3 (Set) to save and exit. The remote will display a clock Icon when counting down. Park Area Location: This allows you to enter the location of your parked vehicle in a parking lot or parking garage. Use menu on right to enter location. Press button # 3 to save and exit. Power Save Mode: This mode saves battery power by turning off all menu screens.
PAGE 10
ALARM CLOCK: Scroll-Wheel UP To set Alarm Clock, press button #2. Enter the time of alarm (in 24 hour) and press button #1 (Enable) then button press #3 (Set). The remote will display will display an alarm Icon on LCD display. To set Alarm Time, Press button # 1 then # 3 To cancel Alarm Time, Press button # 2 then # 3 Daily Start: Scroll-Wheel UP This allows you to have vehicle to automatically start the same time every day. To activate daily start, press button # 3.
PAGE 11
Carjack Protection: 2 Modes of Operation Carjack Mode is designed to protect you in a Hold-Up situation. There are 2-ways of activating Carjack, passively thru the doors and actively thru the remote. When Carjack triggers, it will start a 30 second countdown. After countdown, the siren, horn and lights will flash for 3 minutes. Carjack will trigger again when the ignition is turned off and on. The vehicle will not start until Carjack is deactivated. Carjack is programmable ON or OFF.
PAGE 12
Remote Engine Starting: Press and hold the Remote Start Button until the remote control beeps a nd 2 time. 1) Parking lights flash twice and the system will chirp 3 times for audible confirmation. The 2-Way LCD Pager will give voice confirmation “Engine ON”. 2) After the Ignition and Accessory circuits turn for a few seconds, the Starter Motor engages. 3) After Engine Starts and Runs, the Parking Lights flash 3 times. The 2-Way LCD Pager will give voice confirmation “Car Started”.
PAGE 13
IDLE DOWN Mode: (Take Over Operation) This mode allows the remote starter to take over operation of your vehicle while it is parked and idling. The vehicle is put into a remote started condition before you exit and it will remain running for the programmed run time, until you step on brake, or until the remote start button is pressed. Example: You pull up to a convenience store for a quick stop, "Idle Down" mode keeps engine running when you exit the vehicle, (with keys in hand) remote lock/arm alarm.
PAGE 14
Charging Battery: There is a battery Icon on top of display showing battery condition. To recharge battery, plug in USB charger to plug on side of remote control. The battery Button will show battery charging. Crimestopper Security Products Inc. 1770 S. Tapo Street Simi Valley, CA 93063 (800) 998-6880 www.crimestopper.