DIGITAL MEDIA RECEIVER PMX-2
Introduction Dear Customer, Congratulations on your purchase of the world’s finest brand of audio products. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product. Through years of engineering expertise, hand craftsmanship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Specifications Model Operating Voltage Fuse Rating Power Output Max. RCA Output Voltage Output Impedance PMX-2 10.5V - 16V 20A 25 W X 4 @ 4 Ohms RMS 50 W x 4 @ 2 Ohms Peak 4V 500Ω Frequency Response 20 - 20kHz FM Frequency Range 87.5MHz - 107.9MHz AM Frequency Range 530kHz - 1710kHz WB Frequency Range 162.40 - 162.55 (US & Canada) Tuner Presets Clock Display Bluetooth 18 FM / 12 AM / 6 WB No Clock 2.7” Color TFT 3.0+EDR, A2DP 1.3 USB Compatibility 2.
Design Features Rotary Encoder This knob is for adjusting main volume, zone volumes, menu navigation and setting adjustments. REV / FWD button Use this button to skip back and forward through channels or tracks with a short press. Long pressing will activate manual seek mode. MENU button This button gives you access to the main settings of the unit by long pressing. Short pressing will give you access to the settings for the active source.
Wiring Diagram BLACK USB BLACK BLACK RED (REAR LINE OUT RIGHT OR SUB-W OUT) WHITE (REAR LINE OUT LEFT OR SUB-W OUT) GREY RED (FRONT LINE OUT RIGHT) WHITE (FRONT LINE OUT LEFT) RED RED (AUX IN RIGHT) WHITE (AUX IN LEFT) FILTER & FUSE BOX IN 20A FUSE RADIO ANTENNA OUT BLACK WIRED REMOTE 13DIN FEMALE B B ORIENTATION PIN NO.
Installation / Mounting Contents Mounting (Using Mounting Plate) • Source Unit • Screws • Trim Bezel • Power / Speaker Harness • Mounting Plate • Installation & Operation Manual • U Bracket Installation Considerations The following is a basic list of tools needed for installation: • Volt/Ohm meter • Hand held drill w/ assorted bits • Wire strippers • Heat shrink tubing • Wire crimpers • Soldering iron • Wire cutters • Solder • #2 Phillips screwdriver • Heat gun • Battery post wrench • 7mm
Settings AUX INPUT RENAME – To rename AUX, short press the encoder button to set the first letter of the new name. Once active, rotate encoder to adjust letters. Short press the encoder button again to set the next letter. Repeat until AUX has been renamed. Short press MENU to exit and go back up one level. ENABLE - Short press the encoder button to access options. Rotate the encoder button to select if unit is discoverable.
Settings ADJUSTING THE SUBWOOFER OUTPUT Press the SUB + or SUB- buttons to adjust the output level (0-20). ADJUSTING THE SCREEN BRIGHTNESS Short press the SCREEN BRIGHTNESS button to adjust the brightness level. There are two brightness levels. SELECTING A SOURCE TO PLAY Short press the SRC button to show the different source options (FM TUNER>AM TUNER>WB TUNER>USB>AUX>BLUETOOTH>PANDORA>SIRIUSXM). Use the rotary encoder or short press the SRC button to scroll through sources.
Operation ADD PRESETS Short press the encoder button on the ADD PRESETS option. You will need to be on both the station you want to add first. Using this feature allows you to save stations to the unit. Once selected, use the rotary encoder to select the PRESET number (1-6) you want the station saved to. REMOVE PRESETS Short press the encoder button on the REMOVE PRESETS option. You will need to be under the PRESET group you want to adjust first (AM1>AM2).
Operation Pandora® This feature allows you to control the Pandora® app from the source unit directly (Android users will have to use Bluetooth only, iOS users can use both USB and Bluetooth). You will need to start the Pandora® app on your device first, then select the Pandora® source option on the source unit. To use the “Thumbs Up” feature, long press the SUB+ button. To use the “Thumbs down” feature, long press the SUB - button. To play or pause a song, short press the PLAY/PAUSE button.
Troubleshooting Symptom Diagnosis Remedy Basic Blown fuse Check fuse of the unit, replace with correct rating. Vehicle’s ignition is off If connected following the instructions, the unit will not operate with ignition off. Voltage applied to Red wire is not between 10.5 & 16 volts or there is no voltage present Check battery, connections and fuses and repair or replace as necessary. If voltage is above +16 volts, have the electrical system inspected by an authorized service center.
Warranty Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms: Length of Warranty POWER Amplifiers – 2 Years BMW® Direct Fit Speakers – 2 Years Source Units – 1 Year All other products – 1 Year Any Factory Refurbished Product – 90 days (receipt required) What is Covered This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions.
Installation assistance available at: 061115 1230-59187-01-D Printed in China www.rockfordfosgate.com/rftech 600 South Rockford Drive • Tempe, Arizona 85281 United States Direct: (480) 967-3565 • Toll Free: (800) 669-9899 R O C K F O R D F O S G AT E .
