Specifications

STAND
FLIP
360˚ SPIN
VERTICAL SPIN
HYPER SPIN
SOMERSAULT
SIDE FLIP
360˚ LOOP
RC
RADIO CONTROLLED STUNT VEHICLE
MULTI AWESOME STUNTS! MULTI AWESOME STUNTS!
STAND
FLIP
360˚ SPIN
VERTICAL SPIN
HYPER SPIN
SOMERSAULT
SIDE FLIP
360˚ LOOP
RADIO CONTROLLED STUNT VEHICLE
RC
Battery Installation
Note: 1) When replacing Max Rumbler battery:Use alkaline battery only.
2) If the Max Rumbler slows down during play, this may indicate low
battery power, therefore it would be necessary to replace new batteries.
SOLVENT
WATER
MINERAL
SPIRITS
Do not use chemicals
or water to clean.
Gently brush areas
where dirt is trapped.
Wipe down body
with soft cloth.
Switch OFF Transmitter
and Vehicle when not
in use.
Avoid running on
thick carpeting.
Avoid water puddles,
wet grass or rain.
DO NOT pick up
while in motion.
Not for Children
under 8 years old.
UNDER
8
YEARS OLD
UNDER
8
YEARS OLD
Keep fingers, hair and loose
clothing away from the tires
and the wheel hubs
while the Vehicle is switched “ON”.
Do not leave in direct
sunlight for long periods
as damage may occur.
Avoid Sand,
Salt and Mud.
Avoid collisions with
hard surfaces.
Store in cool dry place
and away from direct
heat sources.
Handle carefully,
DO NOT drop it.
Precautions and Care
8+
AGES
RADIO CONTROLLED STUNT VEHICLE
RC
HYPER SPIN!HYPER SPIN!
FLIPS!FLIPS!
360˚ LOOP360˚ LOOP
STANDSTAND
FLIPFLIP
360˚ SPIN360˚ SPIN
SOMERSAULTSOMERSAULT
HYPER SPINHYPER SPIN
VERTICAL SPINVERTICAL SPIN
360˚ LOOP360˚ LOOP
SIDE FLIPSIDE FLIP
WINDOW 79867
12w7.25h8d US
TM
TM
TM
TM
STUNTS
MULTI AWESOME MULTI AWESOME
STUNTS
MULTI AWESOME MULTI AWESOME
MULTI AWESOME STUNTS! MULTI AWESOME STUNTS!
RADIO CONTROLLED STUNT VEHICLE
RC
MULTI AWESOME STUNTS! MULTI AWESOME STUNTS!
CONTENTS AND SPECIFICATIONS MAY VARY FROM THOSE ILLUSTRATED.
79867
WING TAI ROAD EAST,
CHENGHAI, SHANTOU, CHINA
PATENT NO. ZL 2016 3 0013088.0
PATENT NO. 1502382.7M008
fig.1
fig.2
fig.3
Transmitter
1. Turn “ON/OFF” switch to the OFF position for the transmitter.
2. Open the battery compartment cover by loosening the screw (g.4) and
insert AA batteries following the correct polarities (g.5).
3. Replace the battery compartment cover and tighten the screw. (g.6).
Vehicle
1. Turn “ON/OFF” switch to the OFF position for the Max Rumbler.
2. Open the battery compartment cover (g.1) by loosening the screw and
insert AA batteries following the correct polarities (g.2).
3. Replace the battery compartment cover and tighten the screw (g.3).
The Max Rumbler requires 5 “AA” 1.5V (not included) alkaline batteries for the
vehicle and 2 “AA” 1.5V (not included) alkaline batteries for the transmitter.
2.4
FOR MULTI-RACER ACTION
GHz
2.4
FOR MULTI-RACER ACTION
GHz
2.4
FOR MULTI-RACER ACTION
GHz
2.4
FOR MULTI-RACER ACTION
GHz
Battery Care Instruction:
Important! Only adults should replace batteries.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are only to be charged under adult supervision.
Rechargeable batteries are to be removed from the toy before being charged.
Different types of batteries or new and used batteries are not to be mixed.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy.
The supply terminals are not to be short-circuited.
Alkaline batteries are recommended.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
Please keep this information for future reference.
Remove batteries from the product before extended storage.
STAND
To make the Max Rumbler stand, push both
joysticks up to drive forward and gain speed.
At full speed, tap both joysticks down to stand.
FLIP
To flip the Max Rumbler, push both joysticks up
to drive forward. Release both joysticks and
the momentum of the Max Rumbler will flip
itself. The same can be done with both
joysticks down.
360˚ LOOP
To perform this stunt, push both joysticks up to
drive forward and gain speed. At full speed,
hold both joysticks down for 360º Loop.
360º SPIN
For 360º spin, just push the left joystick up and
the right joystick down at the same time. To
spin in the opposite direction, push the left
joystick down and the right joystick up at the
same time.
VERTICAL SPIN
To do this stunt, simply push the left joystick
down. To spin in the opposite direction, push
the right joystick down.
HYPER SPIN
To perform this amazing stunt, push the left
joystick down and simultaneously push the right
joystick up. Hold to gain speed and then push both
joysticks up for Hyper Spin.
SOMERSAULT
To do this stunt, hold the left joystick down to
perform a Vertical Spin. Then slowly tap the
right joystick downwards repeatedly to
advance to a Somersault stunt.
SIDE FLIP
Push both joysticks up to drive forward and
accelerate. Then push the right joystick down
and release the left joystick to flip to the right.
To flip to the left, push the left joystick down
while releasing the right joystick.
Long Press.
Short Press.
Release.
These stunts require practice to perform.
Power
indicator
ON/OFF
Switch
Left Stick
Controls
Forward And
Reverse Of
Left Wheel
Right Stick
Controls
Forward And
Reverse Of
Right Wheel
fig.4
fig.5
fig.6
79867 12w7.25h8d V1.97 EU.ai
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. The manufacture is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.