Enjoy Listening ROBERTS DAB / FM RDS Digital Radio with built-in battery charger Please read this manual before use
Contents Controls .......................................................................2-3 Software version ...........................................................20 Battery operation using alkaline batteries.......................4 System reset.................................................................21 Battery operation using rechargeable batteries ...........5-6 Headphone socket........................................................22 Using the AC adaptor .............................
Controls (Top) 12 11 13 10 9 1 2 3 4 5 6 7 8 1. Speaker 6. Auto Tune button 2. Volume control 7. Info button 10. Auxiliary input socket 11. LCD display 3. On/Off button 8. Preset button 12. Charge / Low battery indicator 4. Favourite button 9. Tuning / Select control 13. Headphone socket 5.
Controls (Rear) 14 15 16 14. Telescopic aerial 15. Line output socket 16. DC input socket 17.
Battery operation using alkaline batteries (also see page 23) 1. Ensure your radio is disconnected from the mains supply and the aerial is fully retracted. 2. Open the battery cover on the base of the unit by using a flat bladed screwdriver to loosen the screw securing the battery cover. 3. Slide the switch inside the battery compartment to the Alkaline position. 2 4. Insert four LR14 (C size) Alkaline batteries into the spaces in the compartment.
Battery operation using rechargeable batteries (also see page 23) The first few times that you charge a new set of batteries, you may find that the charge and play times are very short. Normal operation should be achieved after 3 or 4 charge - discharge cycles. Batteries are only charged while the radio is connected to the mains supply via its adaptor and it is switched off using the On/Off button. 1. Ensure your radio is disconnected from the mains supply and the aerial is fully retracted. 2.
Battery operation using rechargeable batteries cont. • When the batteries are exhausted, the charge/low battery indicator light will show red for a short while. The radio will then switch itself off. It may not be possible to switch the radio back on until the batteries are recharged, or until the radio is connected to the mains adaptor. • If the radio is not to be used for any extended period of time it is recommended that the batteries are removed from the radio.
Operating your radio - DAB 1. Carefully extend the telescopic aerial. 2. Press the On/Off button to switch on your radio. The display will show 'Welcome to DAB'. 3. If this is the first time the radio is used a quick scan of the Band III DAB channels will be carried out. If the radio has been used before the last used station will be selected. 4. During the scanning process, the lower line of the display shows a bar-graph indicating progress of the scan. 5.
Selecting a station - DAB 1. The top line of the display shows the name of the station currently selected. 2. Rotate the Tuning control to scroll through the list of available stations on the lower line of the display. Stop rotating the Tuning control when you find the station that you wish to hear. 2,3 3. Press and release the Tuning control to select the station. The display may show 'Now Tuning...' while your radio finds the new station. 4. Adjust the Volume control to the required setting.
Display modes - DAB Your radio has a range of display modes:1. Press and release the Info button to cycle through the various modes. a. Scrolling text Displays scrolling text messages such as artist/track name, phone in number etc. b. Program Type Displays the type of station being listened to e.g. Pop, Classic, News etc. c. Multiplex Name Displays the name of the DAB multiplex to which the current station belongs. d. Time and date Displays the current time and date. 1 a b c d e.
Finding new radio stations - DAB As time passes new stations may become available. To find new stations proceed as follows:- 1 1. Press and release the Auto Tune button. The display will show 'Scanning...' and your radio will perform a scan of the Band III DAB channels. As new radio stations are found the station counter on the right-hand side of the display will increase and the radio stations will be added to the list stored in the radio. Secondary services - DAB 1.
Manual Tuning - DAB Manual tuning allows you to tune directly to the various DAB Band III channels. UK DAB stations are currently located in the range 11B to 12D. 1. Press and hold in the Info button until the display shows 'Manual Tune'. Press and release the Tuning control to select this function. 1 2. Rotate the Tuning control to select the required DAB channel. 3. Press and release the Tuning control.
Dynamic Range Control settings - DAB Dynamic Range Control (also known as DRC) can make quieter sounds easier to hear when your radio is used in a noisy environment. 1 1. Press the On/Off button to switch on your radio. 2. Press and hold in the Info button. The display will show 'Manual Tune'. 3. Rotate the Tuning control until the display shows 'DRC'. 2 4. Press and release the Tuning control to enter the adjustment mode. 5.
Operating your radio - Search tuning - FM 1. Carefully extend the telescopic aerial fully. 2. Press the On/Off button to switch on your radio. 2 3. Press the DAB/FM button to select the FM band. 4. Press and immediately release the Auto Tune button, your radio will scan in an upwards direction (low frequency to high frequency) and stop automatically when it finds a station of sufficient strength. 5. After a few seconds the display will update. The display will show the frequency of the signal found.
Manual tuning - FM 1. Press the On/Off button to switch on your radio. 2. Press the DAB/FM button to select the FM band. Carefully extend the telescopic aerial fully for FM reception. 3. Rotate the Tuning control to tune to a station. With each click of the control the frequency will change up or down by 50 kHz. 1,6 2 4. When the waveband end is reached the radio will recommence tuning from the opposite waveband end. 5. Set the Volume control to the desired settings. 6.
Display modes - FM The Radio Data System (RDS) is a system in which inaudible digital information is transmitted in addition to the normal FM radio programme. RDS offers several useful features. In FM mode the bottom line of the display can be set to any of the following display options:- 1 a 1. Press and release the Info button to cycle through each of the options. a. Scrolling text Displays scrolling text messages such as artist/track name, phone in number etc. b b.
Favourite button Your radio is fitted with a button which when pressed will automatically select the required waveband and tune to your Favourite radio station. With this button you can store one favourite station from either the DAB or FM wavebands. To set up your favourite station, follow these steps: 1. Carefully extend the telescopic aerial and switch on your radio. 2. Select the desired waveband (DAB or FM) and tune into the required radio station as described on the preceding pages. 3.
Preset stations - DAB and FM To make it easier for you to tune your radio to the stations that you prefer, you may store selected radio stations as presets. Your radio holds presets separately for DAB and FM radio modes. You may set as many or as few presets as you like in each mode. You can easily switch between displaying all DAB stations (or all FM frequencies) and displaying only those that you have set as presets.
Stereo / Mono setting - FM (headphones only) Your radio will play stereo FM broadcasts in stereo provided that the received signal is of adequate strength. However, as a stereo signal becomes weaker the audio signal will become poorer. It may be preferable to force the radio to play the station in mono in order to reduce the level of background hiss. 1. Press the On/Off button to switch on your radio. 2. Tune to the required FM radio station as previously described (see pages 13, 14). 1 3.
Scan sensitivity setting - FM Your radio will normally scan for FM broadcasts which are strong enough to give good reception. However, you may wish the Auto-scan function to also be able to find weaker signals, possibly from more distant radio transmitters. Your radio includes a local / distant option for the Auto-scan function. 1 1. Press the On/Off button to switch on your radio. 2 2. If needed, press the DAB/FM button to select the FM band. 3.
Software version The software display cannot be altered and is just for your reference. 1 1. To view the software version on the display, ensure your radio is in DAB mode and press and hold the Info button for 2 seconds. 2. Rotate the Tuning control until the display shows 'SW version'. Press the Tuning control the software version will appear on the display.
System reset If your radio fails to operate correctly, or some digits on the display are missing or incomplete, it may be possible to restore normal operation by carrying out a System Reset operation on your radio. This will restore the radio's settings to their factory defaults. No presets will be stored, and the list of DAB radio stations will be empty.
Headphone socket A 3.5mm Headphone Socket located on the top of your radio is provided for use with either headphones or an earpiece. Inserting a plug automatically mutes the internal loudspeaker. Please be aware that sensitivity of headphones can vary widely. We therefore recommend setting volume to a low level before connecting headphones in the radio. IMPORTANT: Excessive sound pressure from earphones and headphones can cause hearing loss. Auxiliary input socket 1.
A Few Words about Batteries… Rechargeable batteries Your Roberts Vintage radio has been designed to use a choice of power sources. You may plug it into the mains using the supplied high-efficiency adaptor, or for listening away from the mains you may use either alkaline or rechargeable batteries. We do not recommend the use of carbon-zinc or zinc-chloride batteries. Your Vintage radio uses a range of methods to ensure correct and safe charging of Rechargeable Nickel-Metal-Hydride batteries.
If you use the radio powered from the batteries, the charge/low battery indicator light will be off until the batteries are exhausted. The charge/ low battery indicator light will then show red for a short while before the radio switches itself off. It does this in order that the batteries are not excessively discharged. This would otherwise damage the batteries and shorten their life.
Display backlight 1. When using the radio powered from batteries, the display backlight will be switched on for approximately 12 seconds when any button is pressed. 2. When your radio is powered by the AC mains using the supplied mains adaptor the display backlight will always be on whenever the radio is switched on. USB socket for software upgrade As software updates become available information on how to upgrade your radio may be found at www.robertsradio.co.
General Do not allow this radio to be exposed to water, steam or sand. Do not leave your radio where excessive heat could cause damage such as in a parked car where the heat from the sun can build up even though the outside temperature may not seem too high. It is recommended that the DAB band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the FM band. The name plate is located on the underside of your radio.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. N.B.
