Installation Guide

Robern
701 N. Wilson Ave.
Bristol, PA 19007
800.877.2376
SS512 SAFETY LOCK BOX INSTRUCTIONS – MODEL SLB
General Notes
1. Check to be sure you have the correct kit for your cabinet. Check the box label as well
as the silver label on the inside of the lock box door. The box label describes the cabinet
model the lock box designed to t.
NOTE: This product is only a deterrent. It is not a substitute for proper adult supervision.
2. If you experience any problems with your Lock box, please contact your dealer or
Robern directly by calling our toll free customer service line between 8 a.m. and 4 p.m.
E.S.T. (1.800.877.2376) Have the available serial number and model number.
Robern • 701 N Wilson Ave • Bristol, PA 19007 800 877 2376 • FAX [phone]
A. Lock Box Door with Lock
B. Aluminum Shelves
C. Plastic Shelf Locks
D. Grey or White
Shelf Supports
E. Hinge Pins
F. “Robern” Keys
Part List – SLB
SS512 Lock Box Instructions
Rev 2 9/02
BACK OF
CABINET
BACK OF
CABINET
Install the hinge pins rst into the
lock box, then the shelf support.
A. Slide the
hinge pins in all
the way until
they are ush
with the edge of
the lock box door.
B. Slide the pins
into the shelf supports
using a thin object such
as a screwdriver blade
until they “click” into position.
Note: To remove pins, use a pointed tool in the
groove, push the pin towards the center of the door.
[B]
Install the 2 shelf locks on the top shelf only
before installing
A. Slide the locks on the shelf
B. Once the top shelf is installed, the shelf lock
will slide into the shelf support.
Push in rmly to seat the shelf lock
[A]
[B]
Pick the space in your cabinet to
install the lock box.
A. The lock box uses
3 rows of hinge holes
as shown.
B. The lock set (grey
or white plastic)
position may interfere
with the swing out
magnifying mirror on
M Series cabinets.
The lock box can
be installed to avoid
this mirror.
1
Install the 4 shelf supports
(2 per side)
A. Be sure the rounded sides
are facing towards the center
of the cabinet as shown.
B. The shelf supports may t
tightly. If necessary, tap in
lightly with a small hammer.
2
Install the lock box door
A. Lock box door is
installed using the
hinge pins
B. See gure 4 for hinge
pin installation
3
4
5
Install the lock box shelves.
The shelves lock the system in
place and set the lock cam.
A. Install the shelves as shown.
B. Slide the shelf locks into the
shelf supports as shown in #5
C. Test the lock. The key will only
remove in the locked position.
6
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 1