User's Manual
These instructions do not apply to all vehicles. They are meant as only
as a general guide due to the number of different makes & models. For
Monitor Installation
depending on the angle.
1. Temporarily place the moni-
tor stand in the location that
you have chosen. Make sure
-
block/box or cigarette lighter
-
pending on the cable you are
using
location of the monitor and
the cable route you have
MONITOR POWER CONNECTION
There are two ways to supply the monitor with power, one uses a 12 Volt cigarette lighter
adaptor plugged into the vehicle’s cigarette lighter socket, and the other uses a wiring
harness hard wired to the vehicle’s fuse box.
12 Volt Cigarette Lighter Adaptor Using the Monitor’s ON/OFF Button
1. Choose a route for the cable from the monitor to the cigarette lighter socket. It can be a direct
-
-
3. Plug the 12 Volt cigarette lighter adaptor into the cigarette lighter socket.
4. Press the ON/OFF button to turn the monitor.
Hard Wired to Fuse Box Using the Monitor’s ON/OFF Switch (Fig. 1)
1
2. Remove the fuses from both of the in-line fuse holders.
your chassis ground.
-
8. Press the ON/OFF button to turn the monitor.
-
Toll-Free Help Line 1-800-445-1797 and our in-house technical ser-
VRBCS300W
Back-Up Camera
and Monitor
Before You Install
Parts
Installation Installation
1 - Back Up Camera
1- TFT LCD Monitor
2 - License Plate Bolts & Nuts
4 - In-Line Wire Connectors
1 - Grommet
6 - Cable ties
GIVE US A CALL, WE'LL HELP YOU INSTALL.
1-800-445-1797
PLEASE DO NOT RETURN PRODUCT TO STORE.
Visit us on the WEB
www.vr-3.com
For Information and Technical Assistance,
Call Toll-Free in U.S.A. and Canada.
Hard Wired Using Vehicle’s Reverse Light Circuit for ON/OFF (Fig. 2)
1
2. Remove the fuses from both of the in-line fuse holders.
your chassis ground.
-
LED Power Indictor
Image Orientation Button
Power ON/OFF Button
Power Input Jack
(on side of monitor)
MONITOR CONTROLS
-
DO NOT RETURN
-