User's Manual Part 1

ManualsBrandsRM Acquisition ManualsElectronicsTND 740

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This device complies with FCC SAR exposure limits set forth for an uncontrolled

environment.

SAR compliance for using the equipment in close proximity to the human body has been

evaluated at 0mm.

This equipment must not be co-located or operating in conjunction with any other antenna

or transmitter.

End-users and installers must be provide with antenna installation instructions and consider

removing the no-collocation statement.

Caution!

Any changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Canada Statement

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the

following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils

radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

(1) l’appareil ne doit pas produire de brouillage;

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d’en compromettre le fonctionnement.

This equipment should be installed and operated with a minimum distance of 0mm

between the radiator and your body.

Cet équipement devrait être installé et actionné avec une distance minimum de 0mm entre

le radiateur et votre corps.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune

autre antenne ou émetteur.

Summary of content (7 pages)

PAGE 1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Canada Statement This device complies with Industry Canada’s licence-exempt RSSs.
PAGE 2
Your TND™ 740 Unit Your TND™ 740 Box Contents Caution: Important Safety Information • The device can also be charged using a standard Micro USB charger. Navigation Device 1 TND™ 740 Unit • Use this device at your own risk. • Do not use sharp-edged objects on the device touch screen. 2 Smart mount • Attend to this device only when it is safe to do so. • The device is not waterproof and is not protected against water damage.
PAGE 3
Install the Mount Your TND™ 740 TND™ 740 NOTE: Follow all local laws and regulations governing the placement of the mount. TND™ 740 Smart Mount 1. Select an area with a line of sight to the sky and GPS satellites. 2. Clean and dry the mounting area. 3. Remove the suction cup protective film. Up Volume Power Down DC in (power) Home 4. Attach the two pieces of the mount together and lock into place. AUX out 5. Adjust the angle of the mount. 6. Pull the suction cup lever up to release suction. 7.
PAGE 4
Getting Started 1. TND™ 740 Operating System Home Screen Connect to the Internet. Connect to the Wi-Fi hotspot on your smartphone or to your home Wi-Fi network. 2. Register your device with Rand McNally for updates and support. NOTE: You will be required to register your device in order to receive new updates.
PAGE 5
Features 1 Truck Tools Select to enter truck information, set warnings, and access other tools. 2 Restart Your TND™ 740 1 2 3 Restarting the Device 1. Restart the unit by holding down the power button for 5 seconds, or until you see the Power Off screen. 2. Press Power Off. 3. Once the unit has shut down, press and hold the power button for 2 to 4 seconds to turn it back on. Maps Show location on the map and view navigation instructions.
PAGE 6
More Information Trademarks TND™ is a trademark of RM Acquisition, LLC, d/b/a Rand McNally. For more information • Rand McNally Website randmcnally.com/tnd740 • Support randmcnally.com/support • Accessories store.randmcnally.com • Facebook facebook.com/randmcnally InfoGation is a registered trademark of InfoGation Corporation. Customer Support Local search information provided by CityGrid Media. Call toll-free: Weather data provided by myweather.com.
PAGE 7
Warnings, End-User License Agreement, and Warranty Warnings, End-User License Agreement, and Warranty Pay attention to road conditions and street signs, and obey all traffic and safety laws. Traffic laws and current traffic conditions must always be observed and take precedence over the instructions issued by the Rand McNally® navigation system. The User should be aware of situations where current traffic conditions and the instructions from the navigation system may be in conflict.