User Manual

Rivera Primo’s EQUALIZER MOTOR PLATE is designed to couple the motor and transmission together when using

an open primary belt drive system. Manufactured in the USA from virgin aluminum, the Equalizer will outlast your

motorcycle. It bolts directly to Rivera Primo’s alternator cover (# 2014-0002) and bearing support (#PP-103).

When installing the plate as a unit with the alternator cover & bearing support it is recommended that threadlock be

used with the appropriate bolts. If you’re using studs and locknuts also use threadlock. Ensure that all components are

correctly aligned before using threadlock.

An inch or more of adjustment is available for adjusting belt tension & and transmission alignment. Two thick washers

are supplied to protect the slot indents. The two studs supplied with the kit are intended for use in the two holes in the

left side of the transmission case. Remove the OEM studs and replace them with these. The idler is optional.

For all further information contact Rivera Primo at (562) 907-2600.

12450 Whittier Blvd., Whittier, CA 90602

Tel: (562) 907-2600 Fax: (562) 907-2606

www.riveraprimoinc.com

PP-130 / PP-170

INST

ALLA

TION INTRUCTIONS

for

EQUALIZER

MOTOR PLATE

HOME OF PRIMO

BELT DRIVES

QUALITY & PERFORMANCE SINCE 1973