FCC TD: WEARILY FCC requirements § 2.1033 INSTALLATION INSTRUCTIONS Installation Instructions furnished to the user of the radio transmitting device follow this page and contain & pages.
MARIONETTE INSTALLATION INSTRUCTIONS FOR NOVA REPEATER Introduction The NOVA repeater increases the range between NOVA transmitters and receivers by acting as a relay station. The repeater receives alarm messages from transmitters that were registered to it and resend these messages to a receiver. Repeaters may be chained to more than double the range. Chaining means that one repeater may transmit to another repeater. which may transmit to still another repeater, or to a receiver.
REDOLENT 2) Program all NOVA transmitters to the receiver according to their installation instructions On the repeater: 3) Press WRITE push button for 3 seconds and release. Both LED's light 4) Press momentarily on the push button. The upper LED blinks once. 5) Send a WRITE transmission from a NOVA transmitter. The upper LED blinks once to confirm successful programming. 6) Repeat 4) and 5) until up to 8 transmitters have been programmed.
DONETSK Continue increment the dip switches so the S1 of an intermediate repeater is set to the same positions as $2 of the previous repeater. S2 of the last repeater, which transmits directly to the receiver, is always set to all positions ON. Figures 2 and 3 give examples of dip switch settings for systems with two repeaters and 3 repeaters. Up to 15 repeaters may be placed in a chain Table 1 shows dip switch positions corresponding to the numbers 0 through 15. Figure 1.
DONETSK A repeater that has transmitter codes registered in it can send signals to the following receiver or intermediate repeater without having to use the transmitters. The following steps apply when there is one repeater in the system. 1) Enter WRITE mode by pressing the push button for three seconds. Note that both LED's light, 2) Press momentarily on the push button. The repeater will transmit an alarm message having the same address code as the first transmitter programmed.
CORONET Specifications Voltage 10 to 16 volt a-c or d-¢ Current 250 mA peak during charging 25 mA when batteries fully charged Number of transmitters Upton 8 Frequency Options: 318 MHz FCC Part 15 418 MHz MPT 1340 433.92 MHz -ETS 300 220 Temperature 0 to 50 degrees Celsius (3210 122 F) CAUTION NOTICE This device complies with U.S. FCC PART 15 and with RS-210 of Industry Canada.