Ripl One User Guide v2019.RO.UG.
Caution / Important Before using Ripl, read and follow these instructions. Be kind to your ears. High volume or sound pressure can have damaging effects to your hearing. Before turning on Ripl, please make sure the volume on your output device and sliding volume control in the connector cable are turned to low. Once connected and sound is playing, gradually increase the volume on the Ripl module and to the headphones until you achieve a comfortable level.
Quick Start Guide Contents 1x 2x 2x 1x 1x 1x 1x 1x 4x 1x 1x Ripl Sub Attachment Loops Headphone Attachment Discs Ripl Band Ripl Earphones Package of Foam Tips Ripl Connector Cable Ripl Battery Charger AAA Rechargeable Batteries Hard Shell Case Carrying Bag Instructions 1. Place the batteries inside the battery charger and fully charge until green lights appear. Once fully charged, insert three batteries into the Ripl Sub (Sub). 2.
Once the placement of the disc on the ear cup is identified, then gently peel the protective layer from the base and repeat the above steps. When you have found the comfortable position to secure the base, firmly press and allow the sticker to set for two hours, as shown in Figure 2d. PLEASE NOTE – once you firmly press and attach the base unit to your headphones, the sticker will form a bond and will be very difficult to remove.
When you see “Ripl” appear in your device’s Bluetooth screen, push it to connect the Sub. Once the Sub is connected to your device, you will hear “Connected.” Please note – during your first pairing, you may need to turn off (below) and turn on the Sub more than once. ** insert drawing of side of Sub from earlier user guide 4. If you are using the Sub with headphones, place the Sub on the back of the neck and the headphones over your ears.
Frequently Asked Questions (FAQ) ***Insert 1-5 of original 6. Can I get the products wet? Please use caution and do not allow the Sub or other products to get wet. In the future, we plan to offer water resistant products, but at this time Ripl One water will damage the products. Ripl Limited Product Warranty The Ripl One Year Limited Warranty is a voluntary manufacturer’s warranty.
Specifications Bluetooth version Bluetooth range Sub, operation frequency response 4.1 10m 2.402GHz – 2.480GHz The maximum radio-frequency power 1.41dBm Headphones, frequency response Play time between recharge (approx.) RS-1 rating Water resistance 20 – 20KHz 3 – 4 hours 4.5V, 350mA NOT water resistant Designed and Assembled in the USA Manufactured in China 2019 Ripl, LLC All rights reserved.
The operation frequency band(s) is between 2.402GHz-2.480GHz. The maximum radio-frequency power is ~1.41dBm. IC Requirement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
***back www.helloripl.com v2019.RO.UG.