90mm 108mm Beams Spotlight 02_Spotlight_MANUAL.
1. Set up your Spotlight. Download the Ring app. Set up your Ring Beams Bridge. The Bridge connects your Ring Beams lights to the rest of your Ring system. To set up your Bridge, follow the instructions in the Ring app or Bridge user manual. The app walks you through setting up and managing your Spotlight. Search for “Ring” in one of these app stores, or visit: ring.com/app If you do not own a Bridge, don’t worry. Your Spotlight will work fine, but you won’t be able to control it in the app.
Insert the batteries. Set up your Spotlight in the Ring app. Twist and pull off the front of the light, then press the side buttons on the battery compartment to open. In the app, tap Set Up a Device. Insert four D-Cell batteries, then slide the battery cover back onto your Spotlight. 4 02_Spotlight_MANUAL.indd 5 Doorbells Security Cams Chimes When prompted, select Beams and follow the in-app instructions.
2. Install your Spotlight. Hold the base against the surface and drive the three mounting screws. Loosen the locking screw on the base and remove the base from your Spotlight. Insert your Spotlight into the base at your chosen angle and tighten the screw. Use the base as a template to mark the screw holes. Your Spotlight detects motion best when mounted 8-12 feet above the ground. 6 02_Spotlight_MANUAL.indd 7 Loosen the side screw on your Spotlight, rotate to desired angle, and tighten the screw.
For additional help, visit: ring.com/help Or give us a call… US 1 800 656 1918 Canada 1 855 300 7289 Worldwide +1 310 929 7085 For a list of all our customer support numbers, visit: ring.com/callus To review your warranty coverage, please visit www.ring.com/warranty. Patents: www.ring.com/patents © 2018 Ring LLC or its affiliates. RING, ALWAYS HOME, and all related logos are trademarks of Ring LLC or its affiliates. Last updated: 09/28/18 02_Spotlight_MANUAL.
Warnings This device complies with part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. de moin de 20 cm. Installer les antennes de facon à ce que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’ antenne. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.