Quick Start Guide ln-app Setup 1. Make sure your Ring Alarm is disarmed. 2. In the Ring app, tap Set Up a Device and find the Contact Sensor in the Security Devices menu. 3. Follow the in-app instructions to complete setup. Installation 1. Install the sensor and magnet on a door or window and frame. 2. Clean the area before you peel the backing and stick on the sensor and magnet. 3. Make sure there is no more than 1 inch (25.4 mm) between the sensor and magnet when the door or window is closed.
Spacing 0 1II CJ) 0.5" max C ·L Leave at least a 1/ 2 inch (12.7 mm) space so you can open the battery compartment. Ensure no more than 1 inch (25.4 mm) between sensor and magnet when the door or window is closed. Placement ✓ ✓ ©2020 Ring LLC or its affiliates. Ring, Always Home, and all related logos are trademarks of Ring LLC or its affiliates.
IMPORTANT PRODUCT INFORMATION Safety and Compliance Information Use Responsibly. Read all instructions and safety information before use. SAFETY INFORMATION Ft\. l_!J FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE. BATTERY SAFETY Ft\. L!J This product contains lithium coin batteries. This device requires batteries for use. Only use new CR2032 3V batteries. Never mix old and new batteries.
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna • Increase the separation between the equipment and receiver. • Connect the equipment to a socket on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
Ring Contact Sensor Z-Wave Device Specific Key(DSK) Z-Wave OSK: 3..Q.li7-30884-31750-58534-39598 -19048-14192-36424 Ring Contact Sensor Z-Wave Device Specific Key(DSK) Z-Wave DSK:4.