English Information Introduction This manual contains detailed instructions and notes on the operation and use of this machine. For your safety and benefit, read this manual carefully before using the machine. Keep this manual in a handy place for quick reference. Important Contents of this manual are subject to change without prior notice. In no event will the company be liable for direct, indirect, special, incidental, or consequential damages as a result of handling or operating the machine.
Laws and Regulations Legal Prohibition Do not copy or print any item for which reproduction is prohibited by law. Copying or printing the following items is generally prohibited by local law: bank notes, revenue stamps, bonds, stock certificates, bank drafts, checks, passports, driver's licenses. The preceding list is meant as a guide only and is not inclusive. We assume no responsibility for its completeness or accuracy.
Notes to USA Users of FCC Requirements English Part 15 of the FCC Rules ❖ Declaration of Conformity This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Part 68 of the FCC Rules ❖ FCC Requirements 1) This equipment complies with Part 68 of the FCC rules and requirements adopted by the ACTA. On the cover of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXXX. If requested, this number must be provided to the telephone company. 2) This equipment uses the RJ11C USOC jack.
Important Safety Instructions English When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. 2. Avoid using a telephone (other than a cordless type) during an electrical storm.
Notes to Canadian Users of SP 100SF This product meets the applicable Industry Canada technical specifications. The Ringer Equivalence Number is an indication of the maximum number of devices allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices does not exceed five.
Note to users in Canada English Note This Class B digital apparatus complies with Canadian ICES- 003. Remarque concernant les utilisateurs au Canada Avertissement Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Notes on Lamp(s) Inside This Machine Notes to Users in the State of California Perchlorate Material-special handling may apply, See www.dtsc.ca.gov/ hazardouswaste/perchlorate 7 Meihua̲NA̲Safety.
Safety During Operation In this manual, the following important symbols are used: R WARNING: Indicates a potentially hazardous situation which, if instructions are not followed, could result in death or serious injury. R CAUTION: Indicates a potentially hazardous situation which, if instructions are not followed, may result in minor or moderate injury or damage to property. Environments Where the Machine Can be Used R WARNING: • Do not use flammable sprays or solvents in the vicinity of this machine.
• Do not obstruct the machine's vents. Doing so risks fire caused by overheated internal components. English • Keep the machine away from salt-bearing air and corrosive gases. Also, do not install the machine in places where chemical reactions are likely (laboratories, etc.), as doing so will cause the machine to malfunction. Handling Power Cords and Power Plugs R WARNING: • Do not use any power sources other than those that match the specifications shown in this manual.
• Be sure to disconnect the power cord from the wall outlet at least once a year. • The power cord's inner wires are exposed, broken, etc. • The power cord's coating has a crack or dent. • When bending the power cord, the power turns off and on. • Part of the power cord becomes hot. • The power cord is damaged. • If any of the above conditions exist, do not use the power cord and consult your dealer or service representative. Use of the power cord could result in fire or electric shock.
English • If metal objects, or water or other fluids fall inside this machine, you must turn off its power immediately. After turning off the power, be sure to disconnect the power cord plug from the wall outlet. Then contact your service representative and report the problem. Do not use the machine. Doing so could result in fire or electric shock. • Do not touch this machine if a lightning strike occurs in the immediate vicinity.
Handling the Machine's Interior R WARNING: • Do not remove any covers or screws other than those explicitly mentioned in this manual. Inside this machine are high voltage components that are an electric shock hazard and laser components that could cause blindness. Contact your sales or service representative if any of the machine's internal components require maintenance, adjustment, or repair. • Do not attempt to disassemble or modify this machine. Doing so risks burns and electric shock.
English • Do not store toner (new or used) or toner containers anywhere near naked flames. Doing so risks fire and burns. Toner will ignite on contact with naked flame. • The following explains the warning messages on the plastic bag used in this product's packaging. • Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies and small children at all times. Suffocation can result if polythene materials are brought into contact with the mouth or nose.
Safety Labels of This Machine This section explains the machine's safety information labels. Positions of RWARNING and RCAUTION labels This machine has labels for RWARNING and RCAUTION at the positions shown below. For safety, please follow the instructions and handle the machine as indicated. 1 2 CHZ073 Do not incinerate toner or toner containers. Toner dust may cause flashback when exposed to an open flame. Do not touch the parts a label indicates. The inside of the machine could be very hot.
ENERGY STAR Program English ENERGY STAR® Program Requirements for Imaging Equipment The ENERGY STAR® Program Requirements for Imaging Equipment encourages energy conservation by promoting energy efficient computers and other office equipment. The program backs the development and dissemination of products that feature energy saving functions. It is an open program in which manufacturers participate voluntarily.