User Manual

Installation and setup for the HA360ss

HomeAware™ Sound Signaler

The HA360ss Sound Signaler will alert you to any important sound- phone –telephone, alarm

clock, kitchen timer, baby etc. The HA360ss alerts you through the HomeAware base unit and

remote receivers located in other rooms.

Step #1) Battery Backup Installation

Install a new 9 volt alkaline type battery into the battery compartment located on the back of

the unit. See diagram for battery door location. When a fresh battery is installed the light on

the front will light up. Battery backup will provide power to the HA360ss for power outages.

Power will be provided for continuous use for up to 7 days, or for short outages up to two

years.

Step #2) Link Button Setup

This procedure will link your HA360ss to your HomeAware Master unit. The Master unit will

also provide an alert to all HomeAware remote receivers. When using the Sonic Alert bridge

unit HA360BU all original Sonic Alert receivers (SA101, SA201, BL300, and SB1000) will

also alert you.

Its best to do the LINK procedure in the same room with the HomeAware Master unit, make

sure the unit is plugged in.

To link the HA360ss to your Sonic Alert HomeAware Master unit follow the steps below.

1) On the Master unit press the

Set Up button.

2) ON the Master unit display scroll up or down using the

TONE & MINUTE buttons scroll

up with the TONE button and down with the MINUTE button until you see the word

LINK

then press ENTER.

3) The word LINK will begin flashing for up to 1 minute until this part of the setup is

finished.

4) At anytime if you need to exit out simply press the back button to exit.

5) Next Press the

link button on the back of the HA360SS signaler. On the Master unit

display the word Baby will begin flashing. At this point you have three choices to select

from, Baby, Alarm clock, and telephone. To select one of the three options you need to

scroll through the display using the

TONE & MINUTE buttons. Scroll up with the TONE

button and down with the MINUTE button. When the display shows the option you want

press the ENTER button. The red LED light on the front will blink several times during

the link process. When done blinking the link setup is complete, .the units are now linked

together and ready to use.

PAGE 1
Installation and setup for the HA360ss HomeAware™ Sound Signaler The HA360ss Sound Signaler will alert you to any important sound- phone –telephone, alarm clock, kitchen timer, baby etc. The HA360ss alerts you through the HomeAware base unit and remote receivers located in other rooms. Step #1) Battery Backup Installation Install a new 9 volt alkaline type battery into the battery compartment located on the back of the unit. See diagram for battery door location.
PAGE 2
Step #3) Sensitivity Switch This procedure will adjust the sensitivity level that the HA360ss will operate at. There are three levels to choose from. The HI setting is the most sensitive setting and will alert you to more sounds. Moving this switch to MED makes it less sensitive and will alert you to less sound. A LO setting filters out the most sound. If you’re not picking up the sound you need to be alerted to simply move the sensitivity switch to a higher setting.
PAGE 3
Sonic Alert’s Limited Warranty The HA360ss Sound Signaler is warranted against manufacturing defects in materials or workmanship for 1 year from the date of purchase. Within thisperiod of time Sonic Alert will repair or replace at our option the HA360ss without charge for parts or labor. FCC Requirements This device complies with part 15 of the FCC rules, and with RSS-210 of Industry Canada.