User Manual

INSTALLATION AND SET UP FOR HOMEAWARE™
HA360BR – Basic Receiver
The HomeAware™ HA360BR Basic Receiver will alert
you to (DOOR, BABY, PHONE, FIRE etc.) with its 5
flashing bright LED’s lights and an icon that will light up,
corresponding with the alert.
Battery Backup Installation
Install (3) 1.5 volt AA alkaline batteries into the battery
compartment located on the back of the unit. Battery
backup will provide power when a power outage has
occurred. Power will be provided for a continuous
outage lasting 7 days, or for short outages up to two
years.
When the BATT icon on the display lights up it is
indicating that the batteries are low and you need to
replace them.
Link Button Set Up
This procedure will link the HA360BR – Basic Receiver
to your HA360M Main unit. The Main unit will also
provide an alert to all HomeAware™ remote receivers.
When using the Bridge unit HA360BU all original Sonic
Alert receivers (SA101, SA201, BL300, and SB1000)
will also alert you.
It is best to do the link procedure in the same room with
the HomeAware™ Main unit, and to make sure the unit
is plugged in.
To link an HA360BR Basic Receiver to your
HomeAware™ Main unit:
1. Press set up button on the Main unit and
the word LINK will be shown on the
display, press Enter. LINK will begin
blinking. (If LINK mode is entered by
accident, simply press the BACK button
to exit and return to the clock.)
2. Press the link button on the side of your
basic receiver (see diagram below) and
the LINK icon on from of unit will light up
3. Upon successful connection, the 5 bright
LEDs will flash three times.
FCC Requirements
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions; (1) This device might not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.