Operation Instructions

Table Of Contents

1/3 2020/5/6

INSTRUCTIONS FOR OPERATION

SETING THE OPERATING CONTROLS

1. This device which one of black lines series with AC 120V power supply. Now, we take 60Hz power

supply to afford power supply of transmitter when it trough rectify. So, there is no troubles with

change batteries forever.

2. Store the controller away from excess heat or humidity .

3. Operation buttons on the panel of transmitter .

key – For fan speed Reverse .

key – For light brightness and light ON/OFF

control .

key – For fan HIGH speed control .

key – For fan MEDIUM speed control .

key – For fan LOW speed control .

key – For fan OFF control .

POWER SWITCH – for POWER ON/OFF

4. Fan control :

Turn the FAN on or off by only touching the FAN SPEED button .

Keep pressing the button in excess of 0.7 second it becomes a

Press the selected speed button to run the fan at the desired .

By press the speed up-down button to select the needed speed.

5. Fan reverse control :

Press the REV button Change the direction of the fan to run

6. Light control :

PAGE 1
INSTRUCTIONS FOR OPERATION SETING THE OPERATING CONTROLS 1. This device which one of black lines series with AC 120V power supply. Now, we take 60Hz power supply to afford power supply of transmitter when it trough rectify. So, there is no troubles with change batteries forever. 2. Store the controller away from excess heat or humidity . 3. Operation buttons on the panel of transmitter . key – For fan speed Reverse . OR OR key – For light brightness and light ON/OFF control .
PAGE 2
Turn the light on or off by only touching the LIGHT button . Keep pressing the button in excess of 0.7 second it becomes a dimmer , the light varies cyclically in 0.8 second . One of the important feature of this control is AUTO-RESUME . After power on , it allows the light return to where it was off . 7. Power switch Turn off the power for Fan and Light GENERAL INFORMATION : This remote controller is designed to separately control your ceiling fan speed and light brightness .
PAGE 3
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.