Operation Instructions

INSTRUCTIONS FOR OPERATION

SETING THE OPERATING CONTROLS

1. This unit operates on a 12 volts battery (not included).

To prevent possible damage if the battery should leak , be sure to remove

the battery when the unit is not use .

2. Store the controller away from excess heat or humidity .

3. This remote control unit is required with 24bit code combinations. To prevent

possible interference from or to other remote units such as garage door

openers, car alarm or security system .

4. Operation buttons on the panel of transmitter .

5. Start the fan

Press the FAN speed button .

6. Turn off the fan :

Press the OFF button .

7. Light control :

Turn the light on or off by only touching the LIGHT CONTROL button .

Keep pressing the button in excess of 0.7 second it becomes a dimmer ,

the light varies cyclically in 0.8 second .

LED display

FAN SPEED button

1、2、3、4、5、6(HIGH)

REV button – Fan reverse

FAN OFF button -

FAN OFF

LIGHT button -

Light ON/OFF or Dimmer

Light ON/OFF and FAN

TIMING button-

2 hour/ 4 hour / 8 hour

PAGE 1
INSTRUCTIONS FOR OPERATION SETING THE OPERATING CONTROLS 1. This unit operates on a 12 volts battery (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. Store the controller away from excess heat or humidity . 3. This remote control unit is required with 24bit code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system . 4.
PAGE 2
GENERAL INFORMATION : This REMOTE controller is designed to separately control your ceiling fan speed and light brightness . The Light ON/OFF button will control the light brightness ON/OFF . The LED indicator on the transmitter will light when the Function button is pressed . INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER 1. Setting the code on your new transmitter . Within 60 seconds of turning the AC power on, press and hole the FAN ON/OFF button for 5 seconds.
PAGE 3
Canada, Industry Canada (IC) Notices This device complies with Canada licence‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Canada, avis d'Industry Canada (IC) Cet appareil est conforme avec Industrie Canada exemptes de licence RSS standard(s).