Operation Instructions

ManualsBrandsRHINE ManualsElectronicsTransmitter

Page: 1/4

Model : UC7224T4

INSTRUCTIONS FOR OPERATION

SETING THE OPERATING CONTROLS

1. This unit operates on 23A a 12 volts battery (not included).

To prevent possible damage if the battery should leak , be sure to remove

the battery when the unit is not use .

2. This device whichone of black linesser ieswith AC 120V power supply.

the color of the ground wire is kelly.

3. Store the controller away from excess heat or humidity .

4. This remote control unit is required with 24bit code combinations. To prevent

possible interference from or to other remote units such as garage door

openers, car alarm or security system . If you find that your fan and light

kit go on and off without using your control , simply change the combination

code in your transmitter and receiver .

5. Operation buttons on the panel of transmitter .

key– For fan HIGH speed control.

key– For fan MEDIUM speed control.

key– For fan LOW speedcontrol.

key– For fan OFF speedcontrol.

OR OR key– For light brightness and light ON/OFF control.

Summary of content (4 pages)

PAGE 1
Model : UC7224T4 INSTRUCTIONS FOR OPERATION SETING THE OPERATING CONTROLS 1. This unit operates on 23A a 12 volts battery (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. This device whichone of black linesser ieswith AC 120V power supply. the color of the ground wire is kelly. 3. Store the controller away from excess heat or humidity . 4. This remote control unit is required with 24bit code combinations.
PAGE 2
key– For fan speed Reverse. POWER SWITCH – for POWER ON/OFF 6.Start the fan : Press the fan button to run the fan at the desired . 7.Turn off the fan : Press the OFF button . 8.Light control : Turn the light on or off by only touching the LIGHT CONTROL button . Keep pressing the button in excess of 0.7 second it becomes a dimmer , the light varies cyclically in 0.8 second . One of the important feature of this control is AUTO-RESUME . After power on , it allows the light return to where it was off .
PAGE 3
NOTICE : Thechangesormodificationsnotexpresslyapprovedbythe partyresponsibleforcompliancecouldvoiduser’ ’sauthority tooperatetheequipment. IM PORTANT NOTE:TocomplywiththeFCC RFexposurecompliancerequirements,nochangeto theantennaorthedeviceispermitted.Anychangetotheantennaorthedevicecouldresultinthe deviceexceedingtheRFexposurerequirementsandvoiduser’ ’sauthoritytooperatethedevice.
PAGE 4
doitpascauserd'interférenceet(2)cetappareildoitacceptertouteinterférence, notammentlesinterférencesquipeuventafectersonfonctionnement. RadioFrequency(RF)ExposureInformation TheradiatedoutputpoweroftheWirelessDeviceisbelowtheIndustryCanada(IC) radiofrequencyexposurelimits.TheWirelessDeviceshouldbeusedinsucha mannersuchthatthepotentialforhumancontactduringnormaloperationis minimized. ThisdevicehasalsobeenevaluatedandshowncompliantwiththeICRFExposure limitsunderportableexposureconditions.