User's Manual

1/1
INSTRUCTIONS FOR OPERATION
UC7096T : SETING THE OPERATING CONTROLS
1.This unit operates on AAA 1.5 volts battery*4 (not included).(We use AAA battery*4)
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 16 code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
4.Operation buttons on the panel of transmitter .
FAN(D) key – For fan speed control
甲、 HIàMEDàLOWàOFFà Cycle Operation
FAN AUTO key – Auto temp. set-up à manual à cycle set-up
甲、 Temp. of indoor is lower than set-up temp. OFF
乙、 Temp. of indoor is lower than set-up temp. 0~2℃ LOW SPEED
丙、 Temp. of indoor is lower than set-up temp. 2℃或 4℉ MED SPEED
丁、 Temp. of indoor is lower than set-up temp. 4℃或 8℉ HI SPEED
TIMER key – Set timer option of FAN OR LIGHT
HOUR ▲ key – Have time or temp. up.
HOUR ▼ key – Have time or temp. down.
FAN/REV key – Fan reverse control
LIGHT(@) key – For light brightness and ON/OFF control .
LIGHT DELAY key – Auto off after 3 mins.
5.Start the fan and Turn off the fan:
Press the selected speed button to run the fan at the desired .
6.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .