User's Manual

1/2
INSTRUCTIONS FOR OPERATION
UC7087T LCD thermal remote control manual
SETING THE OPERATING CONTROLS
1.This unit operates on AAA 1.5 volts battery*4 (not included).(We use AAA battery*4)
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is re quired with 16 code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
4.Operation buttons on the panel of transmitter .
FAN(
฀
) key – For fan speed control
HIàMEDàLOWàOFFà Cycle Operation
FAN AUTO key – Auto temp. set-up à manual à cycle set-up
Temp. of indoor is lower than set-up temp. OFF
Temp. of indoor is lower than set-up temp. 0~2℃ LOW SPEED
Temp. of indoor is lower than set-up temp. 2℃ or 4℉ MED SPEED
Temp. of indoor is lower than set-up temp. 4℃ or 8℉ HI SPEED
TIMER key – Set timer option of FAN OR LIGHT
HOUR

key – Have time or temp. up.
HOUR  key – Have time or temp. down.
FAN/REV key – Fan reverse control
LIGHT(
฀
) key – For light brightness and ON/OFF control .
LIGHT DELAY key – Auto off after 3 mins.
5.Start the fan and Turn off the fan:
Press the selected speed button to run the fan at the desired .
6.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .