User's Manual

INSTRUCTIONS FOR OPERATION

MODEL: UC7082TA

SETING THE OPERATING CONTROLS

1.This unit operates on a 12 volts battery (not included).

To prevent possible damage if the battery should leak , be sure to remove

the battery when the unit is not use .

2. Store the controller away from excess heat or humidity .

3. This remote control unit is requipped with 65536 code combinations. To prevent

possible interference from or to other remote units such as garage door

openers, car alarm or security system . If you find that your fan and light

kit go on and off without using your control , simply change the combination

code in your transmitter and receiver .

4.Operation buttons on the panel of transmitter .

HIGH key – For fan High speed .

MED key – For fan Medium speed .

LOW key – For fan Low speed .

OFF key – For fan speed off .

REV key – For fan speed Reverse .

UP LIGHT CONTROL key – For light brightness and ON/OFF control .

DOWN LIGHT CONTROL key – For light brightness and ON/OFF control .

5.Start the fan :

Press the selected speed button to run the fan at the desired .

6.Turn off the fan :

Press the OFF button .

7.Light control :

Turn the light on or off by only touching the LIGHT CONTROL button .

Keep pressing the button in excess of 0.7 second it becomes a dimmer ,

the light varies cyclically in 0.8 second .

One of the important feature of this control is AUTO-RESUME . After power

on , it allows the light return to where it was off .

Page : 3-1

GENERAL INFORMATION :

This REMOTE controller is designed to separetly control your

ceiling fan speed and light brightness . The Light

ON/OFF button will control the light brightness ON/OFF .

The red indicator on the transmitter will light when the button is pressed .

INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER

A. Setting the code on your new transmitter .

1. Remove battery cover .

Press firmly below arrow and slide battery cover off .

2. Slide code switches to your choice of UP and DOWN position .

PAGE 1
INSTRUCTIONS FOR OPERATION MODEL: UC7082TA SETING THE OPERATING CONTROLS 1.This unit operates on a 12 volts battery (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. Store the controller away from excess heat or humidity . 3. This remote control unit is requipped with 65536 code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system .
PAGE 2
Factory setting is all UP . Do not use this setting . Use ball point pen or small screwdriver . Slide firmly up or down . B. Setting the code on your new Receiver unit . 1. Slide code switches to the same positions as set on your transmitter . They must be set to same positions to work . 2. Replace battery cover on transmitter . 3. Make sure the code switches are on the left positions .
PAGE 3
--Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. The user should not modify or change this equipment without written approval Form RHINE ELECTRONIC CO.,LTD .Modification could void authority to use this equipment.