RFRemotech Radio Frequency Remote Technology Remote Control Products, Remote Controllable Service Firing Module RF1K2 User’s Instruction
Contents Warning !!!------------------------------------------------------------ 1 A. Firing Module------------------------------------------------------ 1 Two Working Modes---------------------------------------------- 1 Specifications------------------------------------------------------ 1 Parts---------------------------------------------------------------- 2 B. Test----------------------------------------------------------------- 2 C.
Warning!!! A. The purpose of this device is to cause the ignition of fireworks. Fireworks are explosives and may cause personal injuries or death to yourself or others, including spectators. You are responsible for the safe and legal use of this device according to the laws and regulations of your country and/or state/province/district. RFRemotech is not responsible for illegal or unsafe use of this device.
Test Current: <10mA Sizes: 61x38x46mm, antenna is retractile and can be folded. Color: Steel grey With Power/Low Power Indication, Firing Indication, RF Signal Indication, Overload Protection (available only when module is inserted 9V battery), Short Warning Indication etc.. Parts: 1-Antenna, retractile and can be folded. 2-Power/Low Power LED, red. Normally the LED is always on when 3-position switch is at ARM or TEST. When batteries are low, the LED blinks.
interrupted, or the wires are not connected well. Only when the connection is tested to be in good condition, the igniter / ematch can fire successfully. C. Matchable Transmitters Transmitter A Dividual Firing Transmitter Transmitter B Interval Firing Transmitter Transmitter C Stepper Firing Transmitter A firing module can work with 3 types of transmitter: Transmitter A-Dividual Firing Transmitter: Normally it is a 12 button transmitter, a button can fire a firing module individually.
Users should be aware of the following information or should do some operation below. It’s better users clear codes of firing module before make the module learn transmitters. Only when a firing module learns codes of transmitters, it can work with the transmitters. If Transmitter B or Transmitter C is learned but Transmitter A is not learned, Transmitter B or Transmitter C will not function.
Use Transmitter A to learn Group Sequence. Keep pressing button LEARN #4 and don’t release until the 3-Position Switch #5is shifted from OFF to ARM, GREEN of LEARN/FIRE LED #6 blinks continuously, the firing module is in the mode Group Sequence Learning.
available RF signal, the GREEN of LEARN/FIRE LED will blink a time. Mode 1: Dividual Firing Shift 3-Position Switch #5 to ARM, when the module RF1K works with Transmitter A-Dividual Firing Transmitter (see the sample above), it can be activated by the learned button of the transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.