Firing Module RF1A2 User’s Instruction ` Cues can be activated in sequence with 12 intervals RFRemotech Radio Frequency Remote Technology Remote Control Products, Remote Controllable Service
Warning!!! 1. Only the person who has Fireworks licence is allowed to purchase the product, or the person of whom there isn’t fireworks purchase limitation in his/her country or district is allowed to purchase the product. RFRemotech/E-MadeinCHN is not with responsibility for any illegal usage. 2. If RED of LEARN/FIRE LED 3(left) keeps turned on though 3-position switch is OFF, don’t use the receiver any more, the receiver will fire e-match or igniter without any operation.
Model No.
2.Receiver Model No.: Firing Module RF1A2, Cue: 1 Cue Power: 6LR61 9V battery Firing current: >750mA, Max. 6000mA Test current: <10mA Sizes: 61x38x46mm, antenna is retractile and can be folded. 1-Antenna, retractile and can be folded. 2-Power/Low Power LED, red. Normally the LED is always on when 3-position switch is at ARM or TEST. When batteries are low, the LED blinks. 3-TEST LED/ LEARN/FIRE LED,dual colours yellow&red.
Before Use Put 6LR61 9V battery into battery enclosure. Learn Code Receiver must learn code of transmitter button, so that transmitters will work with receiver together. Only when Transmitter A is learned by receivers, Transmitter B can be learned by the same receivers, otherwise Transmitter B is invalid.
2. Fire When exterior circuit is tested coherent, shift 3-position switch to ARM, press a button of Transmitter A or B, RED of LEARN/FIRE LED will blink once, firing current will be sent out. Please note, in ARM status, receiver can be re-activated after 5 seconds. For example: 1x Transmitter A TCL2000-12LN; 1x Transmitter B TCL2000-12LNX; 12x Receiver RF1A2: RX1, RX2, RX3, … , RX12.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.