User Manual

ManualsBrandsRFRemotech ManualsElectronicsRF12A

MS12Q

Wireless Firing System

For Pyrotechnics and Fireworks Show

RFRemote

ch Radio Frequency Remote Technology

Remote Control Products, Remote Controllable Service

Warnings:

The purpose of this device is to cause the ignition of fireworks. Fireworks are explosives and may cause

personal injuries or death to yourself or others, including spectators. You are responsible for the safe and

legal use of this device according to the laws and regulations of your country and/or state/province/district.

RFRemotech is not responsible for illegal or unsafe use of this device. The buyer/user assumes all

responsibility and liability in the use of this device and further agrees, by purchase and/or use of this device,

to indemnify and hold harmless RFRemotech against all liability for injury, loss, or damage direct or

consequential arising out of the use of, or inability to use this device.

You must perform the safety tests (Page 4) every time

you use the system.

Model:RF12A

Summary of content (6 pages)

PAGE 1
Model:RF12A MS12Q Wireless Firing System For Pyrotechnics and Fireworks Show RFRemotech Radio Frequency Remote Technology Remote Control Products, Remote Controllable Service Warnings: The purpose of this device is to cause the ignition of fireworks. Fireworks are explosives and may cause personal injuries or death to yourself or others, including spectators. You are responsible for the safe and legal use of this device according to the laws and regulations of your country and/or state/province/district.
PAGE 2
Contents Warnings------------------------------------------------------------------------------------ P1 Contents------------------------------------------------------------------------------------- P2 A.
PAGE 3
   Type: OOK, 433.92MHz. Transmitting Range: 100-2000m. Safety ON/OFF switch prevents misfires. 2) Firing Module  Model No.: RF12A  Cue: 12 cues  Power: (Either internal or external) Internal batteries: 6xAA battery, rechargeable or disposable; External Power: 6-20VDC, SLA is recommended.  Firing current: >750mA, Max. 10A  Test current: <40mA  Size: 154mmx108mmx52.5mm, antenna is retractile and foldable.
PAGE 4
External battery: Plug alligator clip wire into External Battery Jack (#6), and use red alligator clip to connect the positive (red) terminal of the SLA battery, and black alligator clip to connect the negative (black) terminal. The firing module will work with either internal batteries or external powers. It will use the power with the higher voltage. 2) Safety Tests Do following steps before attaching e-matches / igniters. Step 1: Turn on the Main Switch (#7) and set Rocker Switch (#3) to Learn.
PAGE 5
◆ Arm◆ Once the e-matches/igniters have been tested (previous paragraph), the firing module is ready to fire them. Extend the Antenna (#1), turn on the Main Switch (#7) and set Rocker Switch (#3) to Arm, Arm LED (#4) will be lit. Press a button on a “learned” (see “Learn Codes” above) transmitter to send a signal, Cue Fire LED (#9) will flash, and the e-match/igniter on that cue will fire. See “B. How system works in Two Different Firing Modes” for more details.
PAGE 6
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.