User's Manual

Manual of TCF200-6XT
Model No.: TCF200-6XT
FCC ID:YMU-6XT
Brand：
：：
：
Modulation Mode: FSK
Frequency: 433.92MHz
Operating Voltage: 12V Alkaline Battery
Range: 200m
TCF200-6XT is a special transmitter with 6 buttons-Start, Stepper, Pause,
continue, Stop & Lock/Unlock for working with RFRemotech receivers. Turn on
the switch, Indicating LED is on in Red brightly and transmitter enters into
Standby & Unlock Status. Transmitter will enter Lock Status automatically after
30 seconds.
Under Unlock Status, press Start button to send Start Command, Indicating
LED is on in Green; press Stepper button to send Stepper Command, Indicating
LED is blinking in Green; press Pause button to send Pause Command,
Indicating LED is on in Yellow; press Stop button to send Stop Command to the
receiver, Indicating LED is on in Red brightly; press Lock/Unlock Button to Lock
the transmitter and Indicating LED is on in dim Red.
Under Lock Status, Stepper, Pause, continue, Stop buttons are not available
until Lock/Unlock Button is pressed for unlock the transmitter.
IMPORTANT REGULATORY INFORMATION
This device complies with Part 15 of the FCC Rules: Operation is subject to
the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference that is received, including any interference
that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.