User Manual

ManualsBrandsRF Technologies ManualsElectronics30011534001

A20-EC Antenna

Installation Manual

Warnings ...................................... 2

Included In This Package ............. 3

About Antennas ............................ 4

Placement .....................................5

Mounting............................................6

Installing ...................................... 7

Technical Specification ................ 7

Summary of content (8 pages)

PAGE 1
A20-EC Antenna Installation Manual Warnings ...................................... 2 Included In This Package ............. 3 About Antennas ............................ 4 Placement ..................................... 5 Mounting............................................6 Installing ...................................... 7 Technical Specification ................ 7 © Copyright 1999, PinPoint Corporation. All rights reserved.
PAGE 2
Warnings The 3D-iD Antenna is intended for indoor use only. Use of the Antenna outdoors can cause damage to its internal components. Contact your PinPoint sales representative for details regarding outdoor use of the 3D-iD system. Do not mount the Antenna in places that are excessively humid or where it is likely to get wet. When placing your antenna, keep in mind that metallic objects, dense walls, microwave ovens and other obstacles can alter radio signals, limiting the Antennas effectiveness.
PAGE 3
Included In This Package 1 Antenna 1 Antenna mount, including: 1 Base plate 1 Mount post 1 Mounting Plate 2 Screws (1/2) 2 Washers 1 Allen wrench 1 Antenna card (optional) CLOSE-UP OF ANTENNA AND MOUNT (ATTACHED)
PAGE 4
About Antennas The 3D-iD Antennas are attached to the Cell Controller and are DC powered by special, low-loss Coaxial Cables. Up to sixteen (16) Antennas may be attached to a single Cell Controller. The Cell Controller generates a 2.44GHzradio signal which it sends to the Antenna via the Coaxial Cable connecting them. The Antenna broadcasts the signals to the surrounding area with an ellipsoidal radiation pattern.
PAGE 5
Antenna Placement Tips The exact location of Antennas will be determined by a certified 3D-iD system integrator. The Antennas will be positioned to optimize the locating capability of the system in accordance with the requiremetns set forth by the customer. The Antennas should be mounted in locations that prevents accidental contact or intentional destruction. Mounting the Antennas near ceilings and out of reach is strongly recommended.
PAGE 6
Mounting the Antenna The Antenna mount is intended for flat walls of varying construction. Please contact your certified 3D-iD system integrator for other mounting applications. 1) Using the appropriate hardware, securely attach the circular baseplate of the mount to a flat surface in the desired location. Ensure sufficient clearance is left between the baseplate and any nearby ceilings and walls to allow for full adjustment of the Antenna once it is mounted. 2) Attach the mounts post to the base plate.
PAGE 7
Installing the Antenna 1) Loosen both set screws on the mount with the enclosed wrench. Align the Antenna so it is oriented in the direction indicated by the system integrator. Tighten both set screws 2) Attach the Antenna to its appropriate Coaxial Cable. For tension relief, insert a tie wrap through theguide on the back of the antenna and secure the Coaxial Cable with the tie-wrap. PICTURE OF MOUNTED ANTENNA Technical Specification Frequency: Tx: 2442 + 83.
PAGE 8
PinPoint Corporation One Oak Park Bedford, MA 01730 http://www.pinpointco.