How-To Guide

4020 Winnetka Avenue, Rolling Meadows, IL 60008
[phone] phone • [phone] toll free • [phone] fax
[e-mail] www.RFIDeas.com
01/20/2020
To Whom it may concern
OEM Responsibilities to comply with FCC and Industry Canada Regulations
The OEM integrator must be aware not to change any RF related parameters or provide
information to the end user regarding how to modify this OEM RF module or change RF
related parameters in the end product or all warranty or certifications will be VOID.
OEM End Product Labeling requirements
The OEM-805N11KU, OEM-805N21KU, OEM-805N11K5 and OEM-805N11K7 modules
are labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC
Certification Numbers are not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label
referring to the enclosed module.
In that case, the final end product must be labeled in a visible area with the following:
“Contains Transmitter Module FCC ID: M9MF80100”
“Contains Transmitter Module IC: 6571A-F80100”
The above OEM modules have been certified for integration into products only by OEM
integrators under the following condition:
The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi-transmitter product
procedures.
As long as the two condition above is met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the FCC and Industry Canada
authorizations are no longer considered valid and the FCC ID and IC Certification Number
cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC and Industry Canada authorization.