User's Manual

solo Desktop Charger Base

The Charger Base is used for storing and charging the Microphone

when not in use. The Microphone must be properly inserted into

the base and seated flush for charging to occur.

1. Charger Bay — charges Microphone

2. LED indicator — mute and pairing status indicator

3. MUTE button — duplicates the Microphone mute function

4. AUDIO port — 2.5mm analog in/out headset connection or

external audio connection

5. Mini USB connector — computer audio connection

6. POWER connector — power supply input

Mute Button

Pressing the MUTE button toggles between muting (flashing RED

LED status) and un-muting (flashing GREEN LED status) the

Wireless Microphone. Note: Pressing the MUTE button on a

Microphone will similarly toggle between mute and un-mute and

show on both status LEDs.

Power Module

The Charger Base requires 5VDC power. Plug the supplied AC

adapter into a convenient 110-240VAC, 50-60Hz

power outlet and the adapter into the power

connector. The power LED on the Charger Base

will flash RED for a few seconds then turn off.

10 seconds, it means that the Microphone needs to be paired to

the system.

Microphone Pairing Instructions

1. Make sure the Microphone is turned OFF (no LED activity). If

the unit is ON, press and hold the MUTE button for 10 seconds

until the LED turns solid RED (do not release when you hear

two beeps), to turn the unit off, if needed. An alternative

method of turning off is to place the Microphone in the Charger

Base for less than 2 seconds.

2. Place the Microphone into pairing mode by holding the

Microphone’s MUTE button down for ten seconds. The LED will

turn solid GREEN and then solid RED. Release the MUTE

button. The Microphone unit is now in pairing mode.

3. Within 5 seconds, push and hold the Charger Base’s MUTE

button for six seconds to enter into pairing mode. The LED will

be solid RED until pairing is confirmed, as indicated by a short

GREEN flash followed by flashing RED on both the

Microphone and the Charger Base. If pairing fails on either

unit, the LED will flash alternately GREEN and RED for a few

seconds.