SUPERSIGNAL
SAFETY INSTRUCTIONS Please read and keep these instructions - All the safety and operating instructions should be read before this product is operated. Safety notice WARNING! Check the device before use. In the event of damage or a defect, the device must not be put into operation. Risk of injury! Risk of injury to children and people with reduced physical, sensory or mental abilities (e.g.
Operational safety Loud or unusual noises can also be a sign of a malfunction. In this case, pull the power adapter out of the socket immediately. Only touch the power adapter by the housing. Never pull the power adapter by the cable. If you are going to be absent for a long period of time or during a thunderstorm, pull the device out of the socket.
Risk of injury WARNING! Excessive sound pressure when using earphones or headphones can cause damage or loss of hearing. Listening with earphones or headphones at a high volume over a long period of time can cause damage to the user. Please check the volume before inserting or putting on earphones or headphones in your ears. Set the volume to a low value and only increase the volume enough that you still find it comfortable. Notes on the radio interface The device generates an electromagnetic field.
Remove leaking batteries from the device immediately and clean the contacts before inserting new batteries. WARNING! There is a risk of explosion if batteries are used improperly! Only use new batteries of the same type. Please never use new and old batteries together in one device. Pay attention to the correct polarisation when inserting the batteries. Never charge batteries. Batteries should only be stored in cool and dry places. Never throw batteries into fire.
TECHNICAL SUPPORT Should you encounter problems using this product, please refer to the troubleshooting section on page 26 of this owner’s guide. Alternatively, call Revo technical support on: +49 (0) 2676 / 9 52 01 01 Alternatively, e-mail support@revo.co.uk or visit the troubleshooting section of our website at: www.revo.co.
FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION Changes or Modifications not expressly approved by the party responsible could void the user’s authority to operate this device.
WARRANTY TELESTAR-DIGITAL GmbH warrants to the end user that this product will be free from defects in materials and workmanship in the course of normal use for a period of one year from the date of purchase. This guarantee covers breakdowns due to manufacturing faults and does not apply in cases such as accidental damage, general wear and tear, user negligence, modification or repair not authorised by TELESTAR DIGITAL GmbH. COPYRIGHTS AND ACKNOWLEDGEMENTS Copyright 2020 TELESTAR DIGITAL GmbH.
CONTENTS SAFETY INSTRUCTIONS............................................................................................................... 2 TECHNICAL SUPPORT .................................................................................................................. 6 ENVIRONMENTAL INFO ................................................................................................................ 6 Declaration of Conformity (RED) .....................................................................
Software Upgrade .................................................................................................................. 25 Viewing Software Version ...................................................................................................... 25 TROUBLESHOOTING .................................................................................................................. 26 SPECIFICATIONS .................................................................................................
WELCOME Thank you for purchasing our SUPERSIGNAL radio, we are sure that it will provide you with many years of enjoyment and reliable service. SUPERSIGNAL is the ultimate expression of our design and engineering philosophy, and the culmination of everything we have learnt in 10 years of award-winning product design and development. Functionalism meets craft and technology, a next-generation audio device that beats at the heart of your musical ecosystem, providing whatever soundtrack you need.
YOUR RADIO Top View 1. button Press to switch on radio or put unit to standby. 2. VOLUME knob Turn clockwise or anticlockwise to adjust volume level Front View 3. Joystick Controllers 7. Scroll Up/Down/Left/Right to browse 4. 5. 8. Display SELECT button 9. Presets 1-5 button Press to confirm selection. Press and hold to store preset stations. INFO button Press to play stored station. 10. MODE button information. Press to switch among DAB, FM, AUX ALARM button and Bluetooth mode.
Rear View 12. DAB/FM antenna 13. RCA sockets Connect to RCA cable (not supplied). 14. AUX IN socket Connect to 3.5mm audio cable (not supplied). 15. DC IN jack Connect to supplied power adapter. 16.
BATTERY REPLACEMENT The SUPERSIGNAL remote control is powered by a single 3V lithium battery. Depending on usage, the battery should happily run for between 1 and 2 years. Replace the battery when button presses seem sluggish, or when the operating range appears to have reduced significantly. Replace the old battery with a new CR2025 lithium cell.
GETTING STARTED Positioning your Radio Place your radio on a flat / stable surface that is not subject to vibrations. Avoid the following locations: ◼ Where the unit will be exposed to direct sunlight. ◼ Where the unit will be close to heat radiating sources. ◼ Where the humidity is high and ventilation is poor. ◼ Where it is dusty. ◼ Where it is damp or there is a possibility of water dripping or splashing onto unit.
Volume Control Turn VOLUME knob anti-clockwise/ clockwise to decrease or increase volume level. Using Headphones You will require headphones fitted with a 3.5 mm diameter stereo plug. The Headphones socket is located at the front of unit. Headphones are not supplied with this radio. Turn down the volume before connecting headphones. Slowly raise the volume with the headphones on until you reach your desired level. Caution: long-term exposure to loud music may cause hearing damage.
DAB MODE Selecting DAB Mode When you turn on the radio it will automatically search and store all the available stations. You should conduct an additional Full Scan to ensure all stations are picked up and stored. It is also recommended every few months to run a new scan to pick up any new DAB/DAB+ that may have begun broadcasting after purchasing your DAB radio. 1. For initial use, your radio will conduct a full scan and store stations list in memory. 2.
Manual Scan This can help you when adjusting your antenna or when adding stations that were missed while auto tuning. 1. Press MENU button, scroll Joystick to select “Manual Scan”, and then press SELECT button to confirm, the display will show the channel number and frequency. 2. Scroll Joystick to select the channel you wanted, and then press SELECT button to confirm.
Storing Preset Stations Your radio can store up to 10 of your favourite DAB. This will enable you to access your favourite station quickly and easily. Storing Preset via main unit: 1. While a program is playing, press and hold one of Presets 1-5 button on main unit to store station directly to preset number 1 - 5. 2. Display will show “Preset stored” and then preset number “P#” will show on the display. Storing Preset via remote control: 1.
FM MODE Selecting FM Mode 1. Press MODE button to select FM mode. 2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise, the last listened FM station will be selected. 3. To manually scan, while FM frequency shows up, scroll Joystick up/down to change frequency by 0.05MHz per step. 4. To automatically scan, while FM frequency shows up, press SELECT button, your radio will automatically search until it reached the next available station.
Storing Preset Stations Your radio can store up to 10 of your favourite FM. This will enable you to access your favourite station quickly and easily. Storing Preset via main unit: 1. While a program is playing, press and hold one of Presets 1-5 button on main unit to store station directly to preset number 1 - 5. 2. Display will show “Preset stored” and then preset number “P#” will show on the display. Storing Preset via remote control: 1.
BLUETOOTH MODE Pair the unit with a Bluetooth device to listen to music: 1. Press MODE button to select Bluetooth mode. 2. The display will show “Bluetooth Discoverable”. 3. Activate your Bluetooth device and look for your radio’s model number “SUPERSIGNAL” in the Bluetooth list. Select it. 4. Display will show “Connected” when connection is successful. 5. To disconnect the Bluetooth connection, press MENU button, and then scroll Joystick to select “Disconnect”, press SELECT button to confirm.
GENERAL OPERATION Setting Alarm Your radio includes dual alarms. Set Alarm, making sure set time at first. 1. Press ALARM button to select “Alarm 1” or “Alarm 2”, and then press SELECT button to confirm. 2. Scroll Joystick to select options, and then press SELECT button to confirm the setting.
Setting Equaliser This feature enables you to choose a sound equalization profile. Each of the equalization setting will change the tone of the sound from your radio when selected. 1. Press MENU button, and then scroll Joystick to select “Equaliser”, press SELECT button to confirm. 2. Scroll Joystick and then press SELECT button to select a profile. The equalization profile options: Normal/Classic/Jazz/Pop/Rock/Speech. 3. To set up My EQ, select “My EQ…”, and then press SELECT button to confirm. a.
Setting Language This feature enables you to change menu language. There are thirteen languages available: English/Danish/Dutch/Finnish/French/German/Italian/Norwegian/Polish/Portuguese/Spanish/ Swedish/Turkish. 1. Press MENU button, and then scroll Joystick to select “Language”, press SELECT button to confirm. 2. Scroll Joystick to select language, and then press SELECT button to confirm.
TROUBLESHOOTING If a problem occurs, it may often be due to something very minor. The following table contains various tips. Problem Solution No Power. ⚫ Ensure the mains cable is properly connected. ⚫ Make sure that the unit is turned on. ⚫ The unit may freeze up during use. Switch the unit off The unit does not respond when pressing any buttons. Poor radio reception. and then on again to reset it. ⚫ Make sure the antenna is fully extended.
SPECIFICATIONS Model: SuperSignal DAB/DAB+: 174 - 240 MHz Radio Frequency: FM: 87.5 - 108 MHz Bluetooth: 2.402 - 2.480 GHz Maximum radio-frequency power transmitted: Bluetooth: 4dBm Speaker Output Power: 15W rms Ecodesign Information Power Consumption Information on Power of Operation Mode: Consumption Power Consumption of Standby Mode: 23.