999CH Restaurant Wireless Calling System User Manual (T114 ) ll Ca Wireless calling system
999CH Restaurant Wireless Calling System T114 User Manual Summary Thanks for choosing this wireless calling system. The receiver host adopts RF wireless and learning code technology. It can easily pair up to 999 channels of wireless calling transmitters and 1 manager remote controller. The receiver host uses advanced industrial micro processor and highsensitivity superheterodyne receiving technology which make the products very stable.
Diagram Function button BACK Vol- Vol+ Down UP SET DEL Antenna Bracket Display DC9V LED indication (4 corners) Bracket Fixed hole Button Function 【BACK】Back to previous menu or standby status. 【Vol-】Volume decrease. 【Vol+】Volume increase. 【DOWN】 Short press to turn down one by one, long press for quick. 【UP】 Short press to turn up one by one, long press for quick. 【SET】 Long press 2sec to enter settings mode; short press to submenu.
Settings Diagram First class Settings menu Second class Settings menu Value Nu m berspk Prompt music M u sic Ding dong Volume Volu m e Display cycle time setting No cycle Delete time setting No delete Timeout prompt time set sec sec SET No prom pt sec Standby Standby 2- k ey m ode Key switch 4- k ey m ode Number registration M anag er TX Note3 Ding dong +No.999 call No.999 call Working mode setting A area No. 99 call Room 99 No. 9 call Room 99 No. 9 em erg ent call Ding dong +No.
Screen Display function Cd8-mode 3: Room mode Cd8-mode 0: Normal mode 1 Room 01~99 Number 001~999 Table 1~9 Cd8-mode 4: Hospital mode Cd8-mode 1: Normal mode 2 Room 01~99 Number 001~999 Bed 1~9 Note: display is same to mode 0, but less dingdong voice.
Operation Instruction 1. Self test when power on When the receiver host is power on, it starts initialization program. The 4 corner LED indicators will flicker and display will show the digits from 000 to 999 along with the prompt music. 2. Function settings At first time using, please do the settings like below. After all the settings are finished, please power off the host and reset. Long press the “SET” button for 2 sec to enter the first class settings menu.
Before do the pairing, please refer to (8) "Cd8" to set the working mode. Such as normal restaurant mode, area mode, room mode or hospital mode. Press "SET" button to enter "Cd7" submenu. The display will show "001", then press "UP/DOWN" to select the number of calling transmitter.
Packing List Name Quantity Receiver host 1 pcs Power adaptor 1 pcs User manul 1 pcs Warranty card 1 pcs FAQ Problems Reasons Solutions While power on, the receiver host has no response. The power adaptor is broken. Change the power adaptor. The signal of some transmitters is not enough. The power of battery is low. Change the battery. Receiver host cannot get some transmitters of them. These transmitters are deleted. Pair these transmitters again to the receiver host.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.