Queue Wireless Calling System User Manual T111/T112 Wireless calling system
CONTENTS Features .................................................01 Technical data ........................................01 Diagram of keypad .................................02 Diagram of receiver ................................03 Button function .......................................03 Operation instruction ..............................04 Paring method ........................................04 Change number pager ...........................04 Charge the receiver ................................
Retekess T111/T112 Queue Wireless Calling System User Manual Summary Thanks for choosing the queue wireless calling system. It adopts RF wireless technology with millions of different learning codes. The system includes 999-channel call buttons keypad and portable buzzer&vibration receivers. The call button keypad has 20 battery charging slots. Each receiver is rechargeable and labeled with a number.
Keypad call button Working voltage DC 5V/6A (power adapter) Working frequency 433.
Diagram of receiver LED1 Charging LED Paper slot Power ON/OFF Reset Pair Mode Built-in battery LED3 LED2 Charging pins Transparent cover Number paper Front Side Back Button function 【Power】 Press and hold the button for 3sec to power on the receiver, press again to power off. Short press the button to reset standby status while there is calling. 【Set】 Short press the button to enter pairing status; Press and hold on the button for 3sec to unpair.. 【Mode】 Change the prompt mode of the receiver.
Operation instruction 1. Connect the call button keypad to power, it executes the self-testing procedure. Then power icon turns on. 2. Press and hold “Power” button for 3s on side of the receiver to power on, the receiver will vibrate and sound 5 times, and then LED1 indicator flickers every 3s, the receiver enters standby status. Plug the receiver to the charging slot, it vibrates and sounds 5 times and then the blue charging LED on, the receiver enters charging status. 3.
Charge the receiver When the voltage of receiver is lower than DC3.2V, it is low power, LED1 and blue charging LED indicator flicker with short buzzer sound, please recharge in time. Plug the receiver to the charging slot, the blue charging LED indicator will flicker, while it is charged full, the LED indicator will turn on all the time. FAQ Problems Reasons Solutions While power on, the number display on keypad is not on. The power adaptor is broken. Change the power adaptor.
Warning Before using this radio, read this guide which contains important operating instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulations. Local Government Regulations When the radios are used as a consequence of employment, the Local Government Regulations requires users to be fully aware of and able to control their exposure to meet occupational requirements.
Warning • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. The CE marking means: Hereby, Henan Eshow Electronic Commerce Co.,Ltd. declares that the radio equipment type is in compliance with the RED Directive 2014/53/EU and the ROHS Directive 2011/65/EU and the WEEE Directive 2012/19/EU.
Warning Avoid Burns Antennas • Do not use any portable radio that has a damaged antenna. If a damaged antenna comes into contact with the skin when the radio is in use, a minor burn can result. WARNING Batteries (If appropriate) • When the conductive material such as jewelry, keys or chains touch exposed terminals of the batteries, may complete an electrical circuit (short circuit the battery) and become hot to cause bodily injury such as burns.
Henan Eshow Electronic Commerce Co.,Ltd Add: Room 722, Sanjiang Building, No.170 Nanyang Road, Huiji Dist rict , Zhengzhou, Henan, China Facebook: facebook.com/RetekessWirelessSystem E-mail: support@retekess.