User's Manual
RE201_Honeywell-Compat_DWS_Instructions.doc
Page 1 of 3 6/29/2011
www.ResolutionProducts.com
Wireless
Security
Solutions
RE201 Honeywell-Compatible Standard Door / Window
Features
• For sensing things that open or separate.
• Magnet and Internal reed switch.
• 2 supplemental hardwire zones.
o Outer terminal.
o Inner terminal.
• Cover tamper.
• Strong, reliable RF signal.
• 10-15 year battery life on CR123A battery.
• Low Battery indication.
Key Instructions
• Battery “+” faces towards spring.
• Panels assume hardwire zone alarm is state in which contact was enrolled.
• Loops:
Reed switch = Loop 2.
External Contact Terminals:
• Outer terminal = Loop 1.
• Inner terminal = Loop 3.
• Center hardwire terminal is common.
• No end-of-line resistors on hardwire zones.
• Ext Loops are: normally closed – alarm on open
Tamper = Loop 4
• Enrolling:
Place Panel in RF Learning mode.
Input Type = RF
Lynx *56 “E I” mode:
To enroll any particular loop: cause the loop to fault…
restore… (panel should beep to indicate ID capture)…
fault… restore… [panel will confirm enrollment].
Vista *56 “10 INPUT S/N: L” mode:
Transmit two open/close sequences.
Press * (to check for duplicate serial/loop number).
Press * (to continue to confirmation screen).
Press * if you wish to skip confirmation; or “Yes” and
activate the loop to confirm.
RE201_Honeywell-Compat_DWS_Instructions.doc
Page 2 of 3 6/29/2011
www.ResolutionProducts.com
Operation
• Magnetic reed switch (Loop 2):
Alarm, when magnet is pulled away from reed switch.
• Hardwire zones (Outer=Loop 1, Inner=Loop 3)
Alarm: when contact changes to alarm condition.
Tamper: none.
• Tamper (Loop 4), when cover is opened.
• Supervisories, every hour.
Specifications
Magnet trip distance: 1 inch nominal
Mounting hardware: # 4 or #6 screws
Replacement Battery: CR123A 1550mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.3x1.4x1.1 inches
Specifications subject to change without notice.
Internal Picture
Loop 1
Outer Terminal Zone
Center Common Terminal
Loop 3
Inner Terminal Zone
Loop 2
Magnetic Reed Switch
Loop 4
Tamper