User's Manual

ManualsBrandsResolution Products ManualsElectronicsTrident Environmental Sensor

RE118 Interlogix

Compatible Trident

™

Environmental Sensor

Trident is an integrated environmental sensor. It detects water

and reports extreme temperature conditions.

Features

• Titanium probes for unmatched corrosion immunity

• IP67 rated waterproof enclosure

• GORE® vent equalizes enclosure pressure

• 5 year warranty

Enroll by placing the panel into wireless enrollment mode and

then sending an enrollment signal from the sensor. The ood

signal is enrolled by default. To Enroll the freeze and heat

zones, remove the sensor cover. Use a wire or a paper clip

to short the desired outer terminal to the center terminal,

shorting one terminal at a time.

DL ID Conguration

• Flood zone is the serial number shown on the device

• Freeze zone is the serial number with last digit

replaced with a 1

• Heat zone is the serial number with last digit replace

with a 2.

Install by placing the sensor in the location requiring water or air

temperature detection. If desired, the wall clip can be used to

secure the Trident sensor.

Optional Wall Clip Securing

• Remove the Trident body from wall clip.

• Secure wall clip to a surface with a #6 mounting

screw.

• Example securing locations: wall, baseboard or

Optional Wall Clip Securing

• Remove the Trident body from wall clip.

• Secure wall clip to a wall with a #6 screw.

• Example securing locations are a wall, baseboard

or cupboard.

Detects water pooled under the sensor and reports extreme air

temperature conditions.

Default Temperature Trip Points

• Heat alarms when over 100.4° F (38° C)

• Heat restores when under 96.8° F (36° C)

• Freeze alarms when under 44.6° F (7° C)

• Freeze restores when over 48.2° F (9° C)

To replace the battery, insert a at blade screwdriver into the

front slot and twist. To reinstall the cover, align the rear latches

and roll the cover forward until it snaps into place.

Mounting Screw Hole

Front slot

Wall Clip

Verify proper enrollment and operation using your control panel’s installation manual.

Summary of content (2 pages)

PAGE 1
UID E G I LL IN STA RE118 Interlogix® Compatible Trident™ Environmental Sensor Trident is an integrated environmental sensor. It detects water and reports extreme temperature conditions. Features • • • • Titanium probes for unmatched corrosion immunity IP67 rated waterproof enclosure GORE® vent equalizes enclosure pressure 5 year warranty Enroll by placing the panel into wireless enrollment mode and then sending an enrollment signal from the sensor. The flood signal is enrolled by default.
PAGE 2
Specifications Physical Housing Dimensions 2.43 x 2.48 x 1.17 inches (6.2 x 6.3 x 3 cm) Weight with Battery 1.34 ounces (38 grams) Mounting Fastener #6 screw (not provided) Environmental Operating Temperature 32 to 120 °F (0 to 49 °C) Maximum Humidity 85% non-condensing relative humidity Water Resistance IP67 rated (waterproof for over 30 minutes at 1 meter depth) Sensor Specifications Frequency 319.