Installation Guide

Outdoor Door/Window Sensor is a full-featured security
transmitter with industry-leading wireless range and battery
life. It is designed to sense the opening and closing of
gates, sheds, and other outdoor open/close applications.
An alarm signal will be transmitted when the magnet is
pulled away from the sensor, or when an external contact is
opened.
Features
• Industry-leading wireless range and battery life
• Wide magnetic gap distance
• Two built-in external contact zones
• Secure encrypted wireless transmissions
• IP67 waterproof enclosure rating
• 5-year warranty
Enroll by placing the panel into wireless enrollment mode
and transmitting an enrollment signal from the sensor.
Interlogix, Qolsys, DSC, and Cryptix sensors can be
enrolled by pulling the battery tab or tampering the unit.
Honeywell and 2GIG sensors can be enrolled by tripping
the unit 3 times or holding the tamper and powering
up the device by pulling the battery tab. Honeywell
and 2GIG sensors must be enrolled as Loop 2 sensors.
Alternatively, all sensors can be enrolled by manually
entering the sensors serial number.
Install by rst attaching the mounting plate and magnet to a
door, window, or fence using screws (provided) or cable ties
(not provided).
Cover-Securing Screw Hole
Use the panel installation guide to verify proper system setup.
Outdoor Door/Window Sensor
I
N
S
T
A
L
L
G
U
I
D
E
I
Mounting Screw Holes
Magnet
Mounting Tips
• Face of mounting plate marked “Flat Mount” is to be
mounted against at surfaces (e.g. square wood post).
• Face of mounting plate marked “Pole Mount” is to be
mounted against round surfaces (e.g. fence post).
Enrollment Signal
• Interlogix External 2
• Power up the sensor while holding the tamper
• Honeywell & 2GIG External 1 & 2
• Should be enrolled as Loop 1 and Loop 3,
respectively. Enroll each external by tripping 3
times
• DSC Externals
• Trip desired external to enroll
Alignment Marks
Resolution Compatibles