Installation Guide

ManualsBrandsResolution Products ManualsElectronicsWireless Door/Window Sensor

The Outdoor Motion Sensor alarms when motion

is sensed. It is battery-powered, with a weatherproof

enclosure.

Features

• IP55 weatherproof enclosure

• Adjustable detection range

• 5-year warranty

Enroll by placing the panel into wireless enrollment mode and

sending an enrollment signal from the motion sensor.

Options for sending an Enrollment Signal

• Remove the battery tab, OR

• Remove the cover to trip tamper

Install by loosening the mounting plate screw and removing

the motion sensor body. Next punch out the mounting

holes and secure the mounting plate to a surface. Finally

place the motion sensor body back onto the mounting plate

and tighten the mounting plate screw.

Mounting

• Mount 2.5 to 4 feet (0.8m to 1.2m) from the

center of the sensor to ground.

• Mount vertically ensuring the sensor is not tilted.

Sensor direction can be changed by removing the cover and

the direction locking part and then turning the sensor. After

changing the sensor direction replace the direction locking

part and cover.

Direction locking

• Direction locking part is removed by prying up

on the pry points with a screwdriver.

Use the panel installation guide to verify proper system setup.

Mounting Plate

Screw

Mounting

Holes

Sky

Ground

Cover Screw

Direction locking part pry point

Outdoor Motion Sensor

Summary of content (4 pages)

PAGE 1
G I UID The Outdoor Motion Sensor alarms when motion is sensed. It is battery-powered, with a weatherproof enclosure. Features • IP55 weatherproof enclosure • Adjustable detection range • 5-year warranty Enroll by placing the panel into wireless enrollment mode and sending an enrollment signal from the motion sensor.
PAGE 2
Detection length can be changed from the default 16.5 feet (5m) detection length to a 6.5 feet (2m) detection length by rotating the lower lens 180 degrees. Do not remove the upper lens. Test the motion using walk test mode which is defaulted to be ON. Turn OFF walk test mode once installation is complete. (Refer to Selectable Modes) Replace the battery by removing the mounting plate and replacing the battery.
PAGE 3
Wall tamper is made active by securing the wall tamper hole with a screw. Motion catch performance is best when the motion sensor is positioned so a person would typically walk across the front of the motion sensor instead of directly toward the motion sensor. Motion Detection Tips • Provide a clear line-of-sight to the monitored area and remember that glass blocks infrared energy. • Aim away from windows and sunlight. • Aim away from air conditioners, heaters or heating/cooling vents.
PAGE 4
Specifications Physical Housing Dimensions 7.0 x 2.7 x 2.1 inches (17.7 x 6.8 x 5.2 cm) Weight with Battery 6.4 ounces (180 grams) Mounting Fasteners #4 or #6 screws (not provided) Environmental Operating Temperature Maximum Humidity Weatherproof -4 to 140°F (-20 to 60°C) 95% non-condensing relative humidity IP55 Sensor Specifications Frequency 433.92 MHz Replacement Battery One Panasonic CR123A Nominal Battery Life 2 years (500 trips per day), 5 years (150 trips per day) Battery Voltage 3.