User's Manual
RE101_GE-Compat_DWS_Instructions.doc Page 1 of 3 29-Jun-11
www.ResolutionProducts.com
Wireless
Security
Solutions
RE101 GE-Compatible Standard Door / Window
Features
• For sensing things that open or separate.
• Magnet and Internal reed switch operation.
• 2 supplemental hardwire zones.
o GE-compatible version reports 2
nd
zone to 2
nd
ID.
• Cover tamper.
• Strong, reliable RF signal.
• 10-15 year battery life on CR123A battery.
• Low Battery indication.
Key Instructions
• Battery “+” faces towards spring.
• No end-of-line resistors on hardwire zones.
• Panels assume hardwire zone alarm is state in which contact was enrolled.
• Center hardwire terminal is common.
• Reed switch and terminal closest to (outer) it are 1
st
ID
• Inner terminal is 2
nd
ID.
• Enrolling:
1
st
ID: Reed switch and outer terminal zone are enrolled by
tamper switch.
2
nd
ID: Inner terminal zone is enrolled by holding down
tamper while installing battery.
Operation
• Magnetic and 1
st
(outer) hardwire zone (1
st
ID)
Alarm, when…
… magnet is pulled away from reed switch.
… contact changes to alarm.
Tamper, when cover is opened.
Supervisories, every hour.
• 2
nd
(inner) hardwire zone (2
nd
ID)
Alarm: when contact changes to alarm condition.
Tamper: none.
Supervisory: every hour.
RE101_GE-Compat_DWS_Instructions.doc Page 2 of 3 29-Jun-11
www.ResolutionProducts.com
Specifications
Magnet trip distance: 1 inch nominal
Mounting hardware: # 4 or #6 screws
Replacement Battery: CR123A 1550mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.3x1.4x1.1 inches
Specifications subject to change without notice.
Internal Picture
Outer Terminal Zone
Center Common Terminal
Inner Terminal Zone
2
nd
ID
Magnetic Reed Switch
1
st
ID