Installation Guide
RESO INC, 1930 Avenue L, Riviera Beach, 33404 FL www.reso-usa.com
INSTALLATION INSTRUCTIONS FOR CASING
TOOL REQUIRED:
- Hammer/ Nail gun/ Glue
- Finish nails
- Measurement Tape
CONTENTS
- 2 Legs – 84 inches with 45 degree cut
- Top piece of casing
INSTALLTION STEPS
STEP 1 PREPARE THE AREA:
• Remove any plastic or cardboard packaging from the door casing, ensuring the clean
surface is exposed for installation.
• Check that the door jamb and surrounding area are clean and free from any
obstructions.
STEP 2 MEASURE AND MARK
• Using a measuring tape and pencil, mark a distance of 1/4 inch from the edge of the
door jamb, going from the inside to the outside. Make these marks along the length of
both sides of the door jamb.
STEP 3 ALIGN THE CASING
• Position the top part of the casing above the door jamb, aligning the pre-cut 45-degree
angle with the top of the jamb