RCS Model SCG5 Z-Wave Keypad INSTALLATION AND OPERATION MANUAL DCN: 141-02273-01 5/19/15
Model: SCG5 Z-Wave Keypad This manual applies to the following product revisions or later revisions up to the next manual revision release: Product Z-Wave Keypad Part No: 001-02273 Firmware Revision 1.00.3 Document Revision History Revision 01 Date 10/20/10 Changes Original release Product Specifications Product Model: Product: SCG5 Scene Control Z-Wave RF communications enabled Keypad Size: Display: Backlight: Contrast: Buttons: Power: 3.5” wide x 4.5” height x 1.2” depth Graphical LCD, 2.75” x 1.
Table of Contents Overview ...................................................................................................................................................... 4 Z-Wave® Installation ................................................................................................................................... 5 Inclusion and Exclusion ............................................................................................................................. 5 Power....................
Overview Z-Wave Keypad The Z-Wave Keypad provides for typical Keypad control plus has the added feature of Z-Wave communications for remote control. The Keypad has a large, backlit graphical display and control buttons. The Keypad can display multiple screens for different functions of the Keypad. Function Control Buttons On-screen dynamic button labels Display operation Keypad control screen Normally the Keypad displays the Keypad control screen as shown above.
Z-Wave® Installation Z-Wave controllers from various manufacturers may support the Z-Wave Wall Controller Device class used by the RCS Z-WAVE Keypad. The following procedure will allow the Keypad to be added to a ZWave network. General Programming Procedure (for controllers supporting the Keypad device class): 1. Set your primary controller to Include mode, to add the Keypad as a node on your network (see your controller’s user manual for detailed instructions). 2.
FCC/IC INFORMATION TO USER This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules.