User's Manual

This charger is designed for Qi-compatible
devices. If your phone does not have built-in
wireless charging capabilities, please use a
certified Qi wireless charging case or receiver.
Refer to your phone's user manual for detailed
features and functions.
1.We suggest to use QC2.0 or QC3.0 adapter
for fast charging.
2.Do not place metal objects, magnets,
magnetic stripe cards, and hard drive based
devices near the wireless charger. It may
cause data corruption.
3.Do not attempt to modify, disassemble, or
repair this product.
4.Do not expose to water, moisture,
or extreme temperatures
( below 40℉ or above 90℉)
Wireless Charging
Phone case that contain metal, magnets, or
are thicker than 3mm will interfere with
wireless charging.
Position your phone in the center of the
designated charging area. You phone will
indicate when charging begins.
WIRELESS
CHARGER
USER GUIDE
Model RW1701
FCC warning:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Any changes or modifications not expressly approved
by the party responsible for compliance
could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different
from that to which the receiver is connected.
IC Caution:
Radio Standards Specification RSS-Gen, issue 5
- English:
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
This device may not cause interference.
This device must accept any interference, including
interference that may cause undesired operation of the
device.
- French:
Cet appareil contient des émetteurs / récepteurs
exemptés de licence conformes aux RSS (RSS)
d'Innovation, Sciences et Développement économique
Canada. Le fonctionnement est soumis aux deux
conditions suivantes:
Cet appareil ne doit pas causer d'interférences.
Cet appareil doit accepter toutes les interférences, y
compris celles susceptibles de provoquer un
fonctionnement indésirable de l'appareil.
-- Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed and
operated with a minimum distance of 20 cm between
the radiator and your bod