User manual

ManualsBrandsRENKFORCE ManualsSpotlightsSolar spotlight Cold white Black

Using Instructions

These instructions relate ONLY to this product and contain important

information for using the product for the first time. Please keep these

instructions for later reference and should always accompany the

product in the event of transference to a new user.

1. Introduction

Dear Costumer,

Thank you for purchasing the solar light. With this solar light you purchased a

product manufactured according to the current state of technology.

This product fulfils all requirements of the valid European and national

egulations. The conformity was proved. The relevant declarations and

documentation are deposited with the manufacturer.

To maintain this state and guarantee a safe operation, you as the user will have

to follow this operating manual!

2. Safety Instructions

- In case of damages caused by not

following this operating manual, the

warranty rights will expire! We exclude

liability for any consequential damages!

- We exclude liability for property or

personal damages caused by inappropriate

handling or not following the safety instructions.

- In these cases any guarantee rights will expire.

Due to safety and admission reasons (CE) it is not allowed to arbitrarily recon-

truct and/or change the solar light.

Therefore, please keep to the operating manual.

The accident prevention rules of the association of the industrial trade coopera-

tive association for electric plants and working material are to be considered in

industrial environments.

3. Usage in Accordance with Requirements

The solar spotlight is automatically switched on at darkness and switched out

in the morning light. The maximum illumination duration with a full accumula-

tor and without recharging is approximately 8 hours. The solar module instal-

led in the upper part of the housing charges the integrated accumulator.

The illumination may be switched on and off via a switch. The three solar

spotlights are suitable for outdoor usage. The spotlights must not be sunk into

water. With the earth pole, it is possible to insert the spotlights into the ground

or, by means of a mounting bracket, screw them to a wall. The solar module

may be installed on a pole, inserted into the ground or screwed to the wall.

The product is designed for the application in a private environment.

Note: Please make sure that the solar module is preferably directed to the

South and that shadows are avoided. When directing the module to the North

it is not possible to use the product. The solar module shall always be free of

snow in the winter.

4. Initiation

1. Please carefully take all parts out of the package and unwrap the accesso-

ries.

2. Via an earth pole, it is possible

to insert the three LED spot-

lights into the ground or, by

means of an assembly plate,

screwed to a wall or floor. The

spotlight may be adjusted via

the ball-and-socket joint.

3. Now choose an appropriate

site for the assembly of the

solar module within the reach of the spotlight. Please note that the site

shall be directed to the south and that no shadow falls on the solar modu-

le. By means of an assembly plate, the spotlight may be screwed to a wall

or floor, or, via an earth pole, inserted into the ground. The spotlight may

also be installed on a post. This is done by means of a pole bracket. Via

the ball-and-socket joint, it is possible to direct the spotlight to the sun.

. Now, connect the 3 plugs of the spotlight with the

sockets of the cables on the solar module.

Note: Those are humidity-protected plugs. Put the

plugs together completely.

. Now set the switch on the back side of the

solar module to the position “ON”. The solar

spotlights are now activated.

Note: During the winter months the duration of

llumination will generally be shorter. If the lamp

should not shine on the first evening, please wait

for a sunny day.

5. Exchange of Accumulators

After one to two years, the capacity of the accu-

mulator pack will decrease. It is then required to

exchange the accumulators. The accumulators

are available in the shops or from the manufac-

turer.

1. Unscrew the 4 screws on the back side of the

solar module and take off the cover.

2. Take the accumulator from the mounting

bracket

3. Insert the new accumulator with correct polarity and close the housing in

reverse order.

Note: Use batteries or accumulators must be disposed of in a non-polluting

way and do not belong into the domestic waste. Your dealer is legally obliged

to take back the old accumulators.

6. Malfunctions

- Lamp is not automatically switched on at darkness

- An outside light source (e.g. streetlight) simulates daylight and pre-

vents the lamp from switching on. Place the lamp at a darker location.

- Lamp is not switched on at darkness or only for a short period of

time.

- Is the lamp connected?

- Accumulator weak or defective. Exchange of the accumulators.

7. Specifications

- Operating voltage: 3,6 V

- Battery: 3 pcs. NiMh 1.2 V/900 mAh AA-size

- Illuminating units: 9 white LEDs

- Illumination time: max. 8 h with a full battery

Manufacturer/Importer/Spare parts:

esotec GmbH, Etzenrichterstr

. 14, D-92729 Weiherhammer

Tel.-Nr: 09605-92206-28, Fax.-Nr: 09605-92206-10,

e-mail:info@esotec.de

Internet:www.esotec.eu

Product Art.-Nr: 102140

Disposal:

Dear customer

please cooperate in avoiding waste. When you intend to dispose of the

product in future, please consider that it contains valuable raw materials

suited for recycling.

Therefore, do not dispose it of with domestic waste but bring it to a col-

lection point for the recycling of waste electrical and electronic equip-

ment.

Thank you very much for your cooperation!

Battery take-back

- Batteries must not be discarded into domestic waste.

- The consumer is legally required to return batteries

after use, e.g. to public collecting centers or to battery

distributors.

- Contaminant-containing batteries are labeled with the

sign “crossed-out trashcan“ and one of the chemical

symbols Cd (= battery contains cadmium), Hg (= bat-

tery contains mercury), Pb (= battery contains lead).

Used batteries should be disposed environmentally

friendly and should not be discarded into domestic

waste. Your dealer is legally required to take back old

batteries.

post-mounting

earth

pole

Srew

screw-

mounting

NiMh

earth

pole