Reliance Communications LLC QSIP7180 Module Instruction Document
Reliance Communications LLC 91 Colin Drive, Unit 1, HOLBROOK, New York 11741, United States
The QSIP7180 has two baseline regulatory certification variants: - Windows or Chromebook for WWAN + Wi-Fi/BT - Regulatory Model: QSIP7180 FCC ID: 2ABGH-RC116LCB Note: This module will not be sold separately, this file is only for FCC application.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following” Contains FCC ID: 2ABGH-RC116LCB”.
47CFR Rules Parts Addressed in Modular Certification Band Applicable FCC Rule Part Band 5 47CFR47 Part 22 Band 2 47CFR47 Part 24 Band 46 47CFR47 Part 15 Subpart E Other 3GPP Bands 47CFR47 Part 27 Wi-Fi 2.4 GHz 47CFR47 Part 15.247 Bluetooth 2.4 GHz 47CFR47 Part 15.247 Wi-Fi 5GHz 47CFR47 Part 15 Subpart E Receive Mode 47CFR47 Part 15 Subpart B Test Standards ANSI C63.10 (Unlicensed) ANSI C63.
The antenna connector is I-PEX type.
For WWAN licensed bands: Allowed maximum gain (dBi), including antenna cable loss Band US FCC Antenna Gain (dBi) 2: US 5 4: US 5.8 5: US 2.1 7: US 5.4 12:US 0.9 13:US 1.3 14:US 1.8 17:US 0.9 25:US 5.1 26:US 2.1 30:US 0 66:US 5.9 71:US 1.1 38:US 5.
Integrated Product Test and CertificationRequirements Integrators must adhere to test guidance provided in FCC KDB 996369 D04 available at this website: https://apps.fcc.gov/oetcf/kdb/forms/FTSSearchResultPage.cfm?switch=P&id=446 37 1. The module has been approved for the rule parts defined in Table 4-1. Host device must betested for Part15B compliance. 2. Radiated emissions testing should be tested per KDB 996369 with all transmitters active andtransmitting at max transmit power.
areless than 20cm from the device during normal operation (i.e. SAR testing is required) in accordance with FCC KDB 447498. Host product manufactures must provide all required documentation to the end user. 6. Antennas must follow the guidelines defined in Section 7. 7. In the US, either a Class II Permissive Change or new equipment authorization is required. Data can be leveraged from FCC ID: 2ABGH-RC116LCB per FCC KDB484596.
