Instructions / Assembly

Organize your parts. You may need a rubber mallet.

Parts :

A: Tabletop

Quantity: 2

IMPORTANT NOTICE:

Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.

Check to be sure that you have all parts.

Remove all wrapping materials, including staples & packing straps before you start to assemble.

Keep all hardware, parts and packaging out of reach of children.

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

Boat Shaped Conference Table • SCTBS7135, SCTBS9543 • INSTRUCTIONS

B: Modesty

Quantity: 1

C: Legs

Quantity: 2

E: Center Support

Quantity: 1

D: Cantilever

Quantity: 2

G: Thumb Screw

Quantity: 8

F: Flat Bracket

PAGE 1
Boat Shaped Conference Table • SCTBS7135, SCTBS9543 • INSTRUCTIONS Organize your parts. You may need a rubber mallet. A D D C B C Parts : A: Tabletop B: Modesty Quantity: 2 Quantity: 1 C: Legs D: Cantilever F: Flat Bracket Quantity: 2 Quantity: 2 E: Center Support G: Thumb Screw Quantity: 1 Quantity: 8 Quantity: 2 IMPORTANT NOTICE: Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts. Check to be sure that you have all parts.
PAGE 2
Boat Shaped Conference Table • SCTBS7135, SCTBS9543 • INSTRUCTIONS Organize your parts. You may need a rubber mallet. STEP 1 : Attach Modesty (B) to Leg (C) by inserting E-Clips into grooves and sliding down into place (See Figures 1 and 2). Please note there are (2) grooves on the inside of Legs (C) and only one on the outside.
PAGE 3
Boat Shaped Conference Table • SCTBS7135, SCTBS9543 • INSTRUCTIONS Organize your parts. You may need a rubber mallet. STEP 4 : Attach Center Support (E) to Modesty (B) by inserting Lockdowels into coordinating holes and pressing down into place (See Figure 3). E LOCKDOWELS Figure 3: Insert Lockdowels into coordinating holes and press down to snap into place B STEP 5 : Attach Tabletops (A) to assembled table by insterting E-Clips into grooves.