Instructions / Assembly
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
C
B
Figure 1
Equal
Equal
1/3 of
table width
1/3 of
table width
1/3 of
table width
MTS46 & MTS60
·
Table Stiffener INSTRUCTIONS
You will need a Phillips Head Screw Driver or Drill and a Tape Measure to Assemble.
Hardware :
A: Self Tapping Screws (Quantity varies according to Stiffener size)
Parts :
B: Table Stiffeners (2) • C: Table Top (may vary) • D: End Caps (4)
A
C D
B
STEP 1A: Slide End Caps(D) onto
the ends of both Table Stiffeners(B)
apply pressure until the holes align.
(see gure 1)
STEP 2: Attach
Table Stiffeners(B) and applied
End Caps(D) to Table Top(C) by using all of the included Screws(A).
STEP 1B: Place Table Top(C) on a clean at surface with
desired table nish face down. Position Table Stiffeners(B)
and applied
End Caps(D)
in the center of the Table Top lengthwise, leaving equal space on each side.
Next position Table Stiffeners(B) and applied
End Caps(D)
spaced evenly across the width.
Note: May be adjusted to accommodate power blocks or other under-the-table accessories as needed.