Instructions / Assembly

ManualsBrandsRegency ManualsFurnitureLegacy Java Stand Up Storage Cabinet

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

IMPORTANT NOTICE:

● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.

● Check to be sure that you have all parts and hardware.

● Remove all wrapping materials, including staples & packing straps before you start to assemble.

● Do not tighten all screws/bolts until completely assembled.

● Keep all hardware parts out of reach of children.

You will need 2 person(s) for this assembly. You will need a Phillips head screw driver.

Stand Up Storage Cabinet LSC4136 • INSTRUCTIONS

Parts: O: Left Door • P: Right Door • Q: Bottom Stringer • R: Top Support(2) • S: Bottom • T: Sides(2)

U: Shelf(2) • V: Back

STEP 1 : Insert 1 Cam Pin(A) into Back(V) and connect/

tighten(gure 1) the Bottom(S) to the back. Also connect Bot-

tom Stringer(Q) as shown below.

Figure 1: To open Cam, point

arrow toward Cam Pin hole.

To lock Cam, turn clockwise.

M N

Hardware :

A: Cam Pin(13) • B: Cam Cap(12) • C: Cam Plug(4) • D: Wood Screw(4) E: Small Screw(32)

F: Hinge(4) G: Hinge Mount(4) • H: Glides(4) • I: Handle(2) • J: Handle Screw(4) K: Shelf Pin(4)

L: Lock Screws(4) • M: Lock Lip • M: Keys(2)

Summary of content (4 pages)

PAGE 1
Stand Up Storage Cabinet LSC4136 • INSTRUCTIONS You will need 2 person(s) for this assembly. You will need a Phillips head screw driver.
PAGE 2
Stand Up Storage Cabinet LSC4136 • INSTRUCTIONS You will need 2 person(s) for this assembly. You will need a Phillips head screw driver. STEP 2 : Screw in 6 Cam Pins(A) into each Side(T). A A A A A A T A STEP 3 : Connect Back/Bottom Assembly from step 1 to the Left Side(T). Also connect both Top Supports(R) to the Left Side(T). Tighten all Cam locks(figure 1). T A A A A A R STEP 4 : Attach Right Side(T) and tighten all cam locks(figure 1).
PAGE 3
Stand Up Storage Cabinet LSC4136 • INSTRUCTIONS You will need 2 person(s) for this assembly. You will need a Phillips head screw driver. STEP 7 : Connect 4 Hinges(F) to the Doors(O,P) with 2 Small Screws(E) each hinge. There are holes that mark the location of the screws to aid in alignment. F F P O F STEP 8 : Connect 4 Hinge Mounts(G) to the Sides(T) with 2 Small Screws(E) each Mount. Ensure that the screw on the mounts are toward the back of the unit when attached.
PAGE 4
Stand Up Storage Cabinet LSC4136 • INSTRUCTIONS You will need 2 person(s) for this assembly. You will need a Phillips head screw driver. STEP 11 : Connect the Handles(I) to the Doors(O,P) with 2 Handle Screws(J) each handle. The open side of the handle should face toward the outside of the unit. STEP 12 : Close the doors(O,P) and place Lock Lip(M) on the Top Support(R) centered in relation to the lock on the Right Door(P).