Instructions / Assembly

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

IMPORTANT NOTICE:

● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.

● Check to be sure that you have all parts and hardware.

● Remove all wrapping materials, including staples & packing straps before you start to assemble.

● Do not tighten all screws/bolts until completely assembled.

● Keep all hardware parts out of reach of children.

LEGACY STORAGE CABINET • LSC2935 • INSTRUCTIONS

Organize your parts and hardware. You will need a Phillips head and at head screw driver and rubber mallet.

Hardware :

A: Mounting Bracket(4) • B: Hinge(4) • C: Lock Lip • D: Door Tooth(2) E: Small Screw(4) F: Cam Pins(8) •

G: Medium Screws(32) • H: Shelf Pins(4) • I: Adjustable Glides(4) J: Large Screws(4) •

K: Door Handles(2) • L: Keys(2)

Parts :

M: Back • N: Front Lip • O: Bottom • P: Sides(2) Q: Shelf • R: Top • S: Door(2)

RQP

STEP 1 : Insert 4 cam pins(F) into top(R).

STEP 2 :Attach brackets(A) to sides(P) using

pre drilled holes with 2 medium screws(G)

each bracket(4). Also insert 2 cam pins(F) in

sides(P).

A A

PAGE 1
LEGACY STORAGE CABINET • LSC2935 • INSTRUCTIONS Organize your parts and hardware. You will need a Phillips head and flat head screw driver and rubber mallet.
PAGE 2
LEGACY STORAGE CABINET • LSC2935 • INSTRUCTIONS STEP 3 : Attach front lip(N) to bottom by inserting dowel rods on front lip(N) into bottom(O). N O STEP 4A : Place side(P) down, pins up and connect bottom(O) as shown below by inserting cam pins into locks and tighteing. STEP 4A : Place Back(M) into place by inserting Dowel rods into holes on Side(P). 4B 4A O O N O M P P STEP 5 : Place second side(P) in place by inserting cam pins into locks and tightening.
PAGE 3
LEGACY STORAGE CABINET • LSC2935 • INSTRUCTIONS STEP 9 : Place door handles(K) onto doors(S) with 2 long screws(J) each. Also use 2 small screws(E) to attach 2 door teeth(D) to the door that is with out the locking mechanism. STEP 10 : Place Locking Lip(D) onto the underside of the top(R) with 2 small screws(E). D K D S E S E D STEP 11 : Place Hinges(B) onto doors(S) with 2 medium screws(G) each. B B B S B S STEP 12A : Connect Doors(S) to mounting brackets(A) on the side walls(P).