Instructions / Assembly

ManualsBrandsRegency ManualsDesksSoucek 42 in. Mocha Walnut Round Breakroom Table

A. Square Top

A2. Round Top

B. Large Base

C. Cylinder

D. Spider

E. Rod

F. Foot (4)

G. Screws (8)

Step 1: Screw 4 feet (F) into base (B) leg

ends.

Step 2: Remove the nut from rod (E) and

set aside.

Step 3: Insert the rod(E) through the hole in

the base (B) and attach nut to exposed rod

end under base bottom.

STEP 4: Next place the cylinder (C) over the

exposed metal rod (E).

STEP 5: Place the exposed end of the metal

rod (E) through the hole in the spider (D) and

twist the second nut back onto the rod until

tight

Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional).

Two people are required for assembly.

Square/Round Table Top INSTRUCTIONS

(MKTBX22, MKTBX30, MKTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848, TTRD30, TTRD36, TTRD42, TTRD48)

Summary of content (5 pages)

PAGE 1
Square/Round Table Top InSTRuCTIOnS (MKTBX22, MKTBX30, MKTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848, TTRD30, TTRD36, TTRD42, TTRD48) Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional). Two people are required for assembly. A A2 B C E F G D Step 1: Screw 4 feet (F) into base (B) leg ends. Step 2: Remove the nut from rod (E) and set aside. STEP 4: Next place the cylinder (C) over the exposed metal rod (E).
PAGE 2
Step 6: Prepare your Template (INCLUDED) by adhereing both template pages to one another on the dashed line. STEP 7: Turn Table upside down. According to your table top(Square or Round) draw 2 diagonal lines across the table as shown below. STEP 8: Place dot 1, located on the template, directly over the crossing lines.
PAGE 3
STEP 9: Once aligned, mark template dots 2,3,4,5 on table bottom. 1 4 2 3 1 4 5 STEP 10: Place table top (A,A2) flat on the floor and set the completed base over the center. 2 3 5 STEP 11: Line Up the marks made on table from step 9 with the holes on the spider arms. Attach using 8 Screws(G) and flip table over. 2 3 1 4 2 3 1 1 4 5 4 2 3 5 5 IMPORTAnT nOTICE Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
PAGE 4
-The Outside dots are for 48” Table tops and MKTBX 36 X-Bases. -The Inside dots are for 30”, 36” and 42” Table tops and MKTBX 22 & 30 X-Bases. 1 LINE UP TOP EDGE OF SECOND SHEET HERE.
PAGE 5
4 5